ExamGecko
Search Search Login
Home Home / Cisco / 200-301
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

DRAG DROP Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right.
DRAG DROP Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right.
DRAG DROP Drag the descriptions of IP protocol transmissions from the left onto the IP traffic types on the right.
What does a router do when configured with the default DNS lookup settings, and a URL is entered on the CLI?
DRAG DROP Drag and drop the application protocols from the left onto the transport protocols that it uses on the right.
DRAG DROP Refer to the exhibit. Drag and drop the networking parameters from the left onto the correct values on the right.
DRAG DROP Drag and drop the characteristics of network architectures from the left onto the type of architecture on the right.
Which REST method updates an object in the Cisco DNA Center Intent API?
DRAG DROP Drag and drop the TCP or UDP details from the left onto their corresponding protocols on the right.
DRAG DROP Drag and drop the TCP/IP protocols from the left onto their primary transmission protocols on the right.

Question 632 - 200-301 discussion

Report
Export

Physical connectivity is implemented between the two Layer 2 switches, and the network connectivity between them must be configured

A.

Configure an LACP EtherChannel and number it as 1; configure it between switches SW1 and SVV2 using interfaces Ethernet0/0 and Ethernet0/1 on both sides. The LACP mode must match on both ends

2 Configure the EtherChannel as a trunk link.

Answers
A.

Configure an LACP EtherChannel and number it as 1; configure it between switches SW1 and SVV2 using interfaces Ethernet0/0 and Ethernet0/1 on both sides. The LACP mode must match on both ends

2 Configure the EtherChannel as a trunk link.

B.

Configure the trunk link with 802.1 q tags.

Answers
B.

Configure the trunk link with 802.1 q tags.

C.

Configure the native VLAN of the EtherChannel as VLAN 15.

Answers
C.

Configure the native VLAN of the EtherChannel as VLAN 15.

D.
Answers
D.
Suggested answer: A

Explanation:

Answer: A

Explanation:

Answer as below configuration:

On SW1:

conf terminal vlan 15 exit interface range eth0/0 - 1 channel-group 1 mode active exit interface port-channel 1 switchport trunk encapsulation dot1q switchport mode trunk switchport trunk native vlan 15 end copy run start on SW2:

conf terminal vlan 15 exit interface range eth0/0 - 1 channel-group 1 mode active exit interface port-channel 1 switchport trunk encapsulation dot1q switchport mode trunk switchport trunk native vlan 15 end copy run start

Show Answer
asked 07/10/2024
Patrick Evelinton de Souza Borges
33 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms