Home / Cisco / 200-301

Question list

List of questions

Question 1

(0)

DRAG DROP Drag and drop the descriptions of file-transfer protocols from the left onto the correct protocols on the right.

Question 2

(0)

DRAG DROP Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right.

Question 3

(0)

DRAG DROP Refer to the exhibit. Drag and drop the networking parameters from the left onto the correct values on the right.

Question 4

(0)

DRAG DROP Drag the descriptions of IP protocol transmissions from the left onto the IP traffic types on the right.

Question 5

(0)

DRAG DROP Drag and drop the application protocols from the left onto the transport protocols that it uses on the right.

Question 6

(0)

DRAG DROP Drag and drop the TCP/IP protocols from the left onto their primary transmission protocols on the right.

Question 7

(0)

DRAG DROP Drag and drop the characteristics of network architectures from the left onto the type of architecture on the right.

Question 8

(0)

DRAG DROP Drag and drop the networking parameters from the left on to the correct values on the right.

Question 9

(0)

DRAG DROP Drag and drop the TCP or UDP details from the left onto their corresponding protocols on the right.

Question 10

(0)

DRAG DROP Drag and drop the IPv6 addresses from the left onto the corresponding address types on the right.

Question 764 - 200-301 discussion

PC1 tries to send traffic to newly installed PC2. The PC2 MAC address is not listed in the MAC address table of the switch, so the switch sends the packet to all ports in the same VLAN Which switching concept does this describe?

MAC address aging

MAC address table

frame flooding

spanning-tree protocol

Show Answer

asked 07/10/2024

Jonas Junker

42 questions

Your answer: A B C D

0 comments

Sorted by