Home

Home / Cisco / 300-415

Question list

List of questions

Question 1

(0)

What are the two advantages of deploying cloud-based Cisco SD-WAN controllers? (Choose two.)

Question 2

(0)

An engineer is troubleshooting a certificate issue on vEdge. Which command is used to verify the validity of the certificates?

Question 3

(0)

What is a benefit of the application-aware firewall?

Question 4

(0)

When VPNs are grouped to create destination zone in Zone-Based Firewall, how many zones can a single VPN be part of?

Question 5

(0)

Which attributes are configured to uniquely Identify and represent a TLOC route?

Question 6

(0)

Which device information is requited on PNP/ZTP to support the zero-touch onboarding process?

Question 7

(0)

Which configuration step is taken on vManage after WAN Edge list is uploaded?

Question 8

(0)

When software is upgraded on a vManage NMS, which two image-adding options store images in a local vManage software repository? (Choose two.)

Question 9

(0)

Which policy configures an application-aware routing policy under Configuration > Policies?

Question 10

(0)

What is a default protocol for control plane connection?

Open VPLUS File

Convert VPLUS to PDF

Related questions

What is a key element used in a vBond Orchestrator redundancy topology?

If Smart Account Sync is not used, which Cisco SD-WAN component is used to upload an authorized serial number file?

Which component of the Cisco SD-WAN control plane architecture should be located in a public Internet address space and facilitates NAT-traversal?

Which command displays BFD session summary information per TLOC on vEdge routers?

A network administrator is configuring a tunnel interface on a branch Cisco IOS XE router to run TLOC extensions. Which configuration will extend a TLOC over a GRE tunnel to another router in the branch?

Which two mechanisms are used to guarantee the integrity of data packets in the Cisco SD-WAN architecture data plane? {Choose two)

Which SD-WAN component is configured to enforce a policy to redirect branch-to-branch traffic toward a network service such as a firewall or IPS?

What is a requirement for deployment of on-premises vBond controllers through the Cisco Plug and Play Connect process?

Which command disables the logging of syslog messages to the local disk?

An engineer creates a data policy to prevent communication from the 172.20.21.0/24 network to the 172.20.41.0/24 network. Which configuration accomplishes this task?

Question 109 - 300-415 discussion

Report

What is an advantage of using auto mode versus static mode of power allocation when an access point is connected to a PoE switch port?

A.

It detects the device is a powered device

B.

All four pairs of the cable are used

C.

Power policing is enabled at the same time

D.

The default level is used for the access point

Show Answer

asked 07/10/2024

Adrian Petrisoaia

35 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first