Question 237 - 300-715 discussion

In the context of a wired 802.1X deployment with Cisco ISE, the requirement is to log failed authentications while minimizing user impact. Let's analyze each option:

A) authentication open - This command configures the port to allow network access regardless of the authentication state. It's useful in situations where specific devices can't perform 802.1X authentication but should still be allowed network access. However, it doesn't specifically address the logging of failed authentications.

B) pae dot1x enabled - PAE (Port Access Entity) refers to the entity on a network device that enforces access control. This command enables 802.1X on the port, which is a prerequisite for implementing 802.1X, but doesn't directly relate to logging failed authentication attempts.

C) authentication host-mode multi-auth - This command configures the port to allow multiple authenticated sessions. This mode is used when multiple devices are connected to the same port (like in a conference room). While it's relevant for 802.1X environments, it doesn't specifically cater to logging failed authentications or minimizing user impact.

D) monitor-mode enabled - This command is used in the context of 802.1X to enable Monitor Mode on a port. Monitor Mode allows a port to grant limited network access to endpoints without 802.1X capabilities. It's often used to ease the deployment of 802.1X by monitoring the authentication status without fully enforcing access control, thereby minimizing user impact. It also helps in logging authentication attempts, including failures.