ExamGecko
Search Search Login
Home Home / Juniper / JN0-280
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Exhibit: Referring to the exhibit, at which interval will the interface be considered down if no hello packets are received?
You are configuring an aggregate route. In this scenario, which two statements are correct? (Choose two.)
When a MAC limiting violation occurs, the switch performs which two actions by default? (Choose two.)
Which statement is correct about the BGP AS path when advertising routes?
What are two device roles in a five-member Virtual Chassis? (Choose two.)
When evaluating BGP routes, what will be evaluated first?
You are troubleshooting a downed BGP session. Referring to the exhibit, what is the cause of the problem?
A generated route is configured under which hierarchy?
Which two statements are correct about EVPN-VXLAN overlay networking? (Choose two.)
What are two reasons why you would deploy an IP fabric instead of a traditional Layer 2 network in a data center? (Choose two.)

Question 13 - JN0-280 discussion

Report
Export

Which Junos OS routing table stores IPv6 addresses?

A.

inet.0

Answers
A.

inet.0

B.

inet0.6

Answers
B.

inet0.6

C.

inet.6

Answers
C.

inet.6

D.

inet6.0

Answers
D.

inet6.0

Suggested answer: D

Explanation:

In Junos OS, routing information is stored in different routing tables depending on the protocol and address family. For IPv6 addresses, the routing table used is inet6.0.

Step-by-Step Explanation:

Routing Tables in Junos:

inet.0: This is the primary routing table for IPv4 unicast routes.

inet6.0: This is the primary routing table for IPv6 unicast routes.

inet.3: This routing table is used for MPLS-related routing.

Other routing tables, like inet.1, inet.2, are used for multicast and other specific purposes.

inet6.0 Routing Table:

When IPv6 is enabled on a Juniper router, all the IPv6 routes are stored in the inet6.0 table. This includes both direct routes (connected networks) and learned routes (from dynamic routing protocols like OSPFv3, BGP, etc.).

Verification:

To view IPv6 routes, the command show route table inet6.0 is used. This will display the contents of the IPv6 routing table, showing the network prefixes, next-hop addresses, and protocol information for each route.

Juniper

Reference:

Junos Command: Use show route table inet6.0 to check IPv6 routing entries.

IPv6 Routing: Ensure that the IPv6 protocol is enabled on interfaces and that routing protocols like OSPFv3 or BGP are properly configured for IPv6 traffic handling.

Show Answer
asked 10/10/2024
Zulkarnain Hashim
39 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms