Home

Home / Juniper / JN0-280

Question list

List of questions

Question 1

(0)

Which two statements about IBGP are correct? (Choose two.)

Question 2

(0)

Exhibit: Referring to the exhibit, which two statements are correct about default BGP advertisements? (Choose two.)

Question 3

(0)

Which two statements are correct about aggregate routes and generated routes? (Choose two.)

Question 4

(0)

Which route is preferred by the Junos OS software routing tables?

Question 5

(0)

Exhibit: How many stages are shown in the exhibit?

Question 6

(0)

Exhibit: Referring to the exhibit, what is the route preference of the 172.25.11.254 next hop?

Question 7

(0)

When considering bidirectional forwarding detection, which two statements are correct? (Choose two.)

Question 8

(0)

How does OSPF calculate the best path to a particular prefix?

Question 9

(0)

Which state in the adjacency process do OSPF routers check the MTU size?

Question 10

(0)

Leaf and spine data centers are used to better accommodate which type of traffic?

Open VPLUS File

Convert VPLUS to PDF

Related questions

Exhibit: Referring to the exhibit, at which interval will the interface be considered down if no hello packets are received?

You are configuring an aggregate route. In this scenario, which two statements are correct? (Choose two.)

When a MAC limiting violation occurs, the switch performs which two actions by default? (Choose two.)

Which statement is correct about the BGP AS path when advertising routes?

What are two device roles in a five-member Virtual Chassis? (Choose two.)

When evaluating BGP routes, what will be evaluated first?

You are troubleshooting a downed BGP session. Referring to the exhibit, what is the cause of the problem?

A generated route is configured under which hierarchy?

Which two statements are correct about EVPN-VXLAN overlay networking? (Choose two.)

What are two reasons why you would deploy an IP fabric instead of a traditional Layer 2 network in a data center? (Choose two.)

Question 23 - JN0-280 discussion

Report

Which operation mode command will display the mapping between the VLAN ID and ports on a switch?

A.

show route

B.

show ethernet-switching table

C.

show interfaces terse

D.

show vlans

Show Answer

asked 10/10/2024

Delano van Kleinwee

40 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first