ExamGecko
Search Search Login
Home Home / Cisco / 350-401
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Which option works with a DHCP server to return at least one WLAN management interface IP address during the discovery phase and is dependent upon the VCI of the AP?
What are two differences between the RIB and the FIB? (Choose two.)
An engineer must update the local web authentication details on a Cisco 5520 WLC. The engineer has one active SSID configured for web authentication and plans to update the virtual interface with a nonroutable IP address. Which command must the engineer apply?
An engineer is troubleshooting the Ap join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?
Which port is required to allow APs to join a WLC when directed broadcasts are used on a Cisco iOS switch?
An engineer must configure a multicast UDP jitter operation. Which configuration should be applied? A) B) C) D)
Reter to the exhibit. Refer to the exhibit. A network engineer must be notified when a user switches to configuration mode. Which script should be applied to receive an SNMP trap and a critical-level log message?
Refer to the exhibit. An engineer must allow R1 to advertise the 192 168.1 0/24 network to R2 R1 must perform this action without sending OSPF packets to SW1 Which command set should be applied?
Refer to the Exhibit. Refer to the exhibit. Which action must be performed to allow RESTCONF access to the device?
Refer to the Exhibit. Refer to the exhibit An engineer is troubleshooting an mDNS issue in an environment where Cisco ISE is used to dynamically assign mDNS roles to users The engineer has confirmed that ISE is sending the correct values, but name resolution is not functioning as expected Which WLC configuration change resolves the issue?

Question 832 - 350-401 discussion

Report
Export

A network administrator received reports that a 40Gb connection is saturated. The only server the administrator can use for data collection in that location has a 10Gb connection to the network. Which of the following is the best method to use on the server to determine the source of the saturation?

A.

Port mirroring

Answers
A.

Port mirroring

B.

Log aggregation

Answers
B.

Log aggregation

C.

Flow data

Answers
C.

Flow data

D.

Packet capture

Answers
D.

Packet capture

Suggested answer: C

Explanation:

This is because flow data is a method of collecting and analyzing information about the traffic flows on a network. Flow data can provide details such as the source and destination IP addresses, ports, protocols, and bytes transferred for each flow. Flow data can help identify the source of the saturation by showing which hosts and applications are generating or consuming the most bandwidth. Flow data can be collected using protocols such as NetFlow, IPFIX, or sFlow. The source of this answer is the Cisco ENCOR v1.1 course, module 10, lesson 10.1: Implementing NetFlow and IPFIX.

Show Answer
asked 10/10/2024
Frank Acosta
38 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms