ExamGecko
Search Search Login
Home Home / Cisco / 350-401
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

What are two differences between the RIB and the FIB? (Choose two.)
Which option works with a DHCP server to return at least one WLAN management interface IP address during the discovery phase and is dependent upon the VCI of the AP?
An engineer is troubleshooting the Ap join process using DNS. Which FQDN must be resolvable on the network for the access points to successfully register to the WLC?
An engineer must update the local web authentication details on a Cisco 5520 WLC. The engineer has one active SSID configured for web authentication and plans to update the virtual interface with a nonroutable IP address. Which command must the engineer apply?
Which port is required to allow APs to join a WLC when directed broadcasts are used on a Cisco iOS switch?
Refer to the exhibit. An engineer must allow R1 to advertise the 192 168.1 0/24 network to R2 R1 must perform this action without sending OSPF packets to SW1 Which command set should be applied?
Refer to the Exhibit. Refer to the exhibit. Which action must be performed to allow RESTCONF access to the device?
Reter to the exhibit. Refer to the exhibit. A network engineer must be notified when a user switches to configuration mode. Which script should be applied to receive an SNMP trap and a critical-level log message?
Refer to the Exhibit. Refer to the exhibit An engineer is troubleshooting an mDNS issue in an environment where Cisco ISE is used to dynamically assign mDNS roles to users The engineer has confirmed that ISE is sending the correct values, but name resolution is not functioning as expected Which WLC configuration change resolves the issue?
Refer to the exhibit. An engineer configures routing between all routers and must build a configuration to connect R1 to R3 via a GRE tunnel Which configuration must be applied?

Question 899 - 350-401 discussion

Report
Export

Refer to the exhibit.

Reler to the exhibit. An engineer a configuring WebAuth on a Cisco Catalyst 9000 Series WIC. The engineer has purchased a third-party certificate using the FQDN of the WLC as the CN and intends to use bit on the WebAuth splash page What must be configured so that the clients do not receive a certificate error?

A.

Virtual IPv4 Address must be set to a routatte address

Answers
A.

Virtual IPv4 Address must be set to a routatte address

B.

Virtual IPv4 Hostname must match the CN of the certificate.

Answers
B.

Virtual IPv4 Hostname must match the CN of the certificate.

C.

Trustpoint must be set to the management certificate of the WLC.

Answers
C.

Trustpoint must be set to the management certificate of the WLC.

D.

Web Au!h Interoepl HTTPs must be enabled.

Answers
D.

Web Au!h Interoepl HTTPs must be enabled.

Suggested answer: B
Show Answer
asked 10/10/2024
Anthony Zaborski
48 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms