ExamGecko
Search Search Login
Home Home / Cisco / 350-601
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibit. An engineer configures FCoE in a newly installed data center. Which configuration must be applied to activate VSAN 100 on VFC100?
Refer to the exhibit. A source is sending a multicast traffic stream to the receiver. How is the multicast traffic expected to flow through the network when it reaches a vPC peer?
Refer to the exhibit. An engineer must access a Cisco UCS C-Series server KVM from a remote location. The engineer must use the out-of-band interface to access the KYM. Which configuration set meets these requirements?
Refer to the exhibit. Refer to the exhibit. An engineer must monitor ingress traffic from SW1 and SW2 port-channel interfaces from SW3. Which configuration must be implemented to accomplish this goal? A) B) C) D)
DRAG DROP Refer to the exhibit. During a recent outage, a network engineer discovered that host A started to experience intermittent connectivity, when Leaf102 was down. Drag and drop the code snippets from the bottom onto the boxes in the code to resolve the problem. Not all code snippets are used.
Refer to the exhibit. Refer to the exhibit. What is the result of executing this python code?
What are two types of FC/FCoE oversubscription ratios? (Choose two.)
Refer to the exhibit. A network engineer must configure the physical domain and attach a VLAN pool to it. Which two commands accomplish this goal? (Choose two.)
Refer to the exhibit. A network engineer configures the VXLAN between the routers in a data center. The VLAN 10 must be extended between routers A and B. The initial VXLAN configuration is completed on RouterA. Which configuration finishes the VXLAN configuration on Router A? A. B. C. D.
DRAG DROP An engineer deploys a custom guest shell rootfs onto multiple switches. Drag and drop the steps from the left into the correct order on the right. Export the Guest Shell rootfs.

Question 166 - 350-601 discussion

Report
Export

Refer to the exhibit.

Cisco Fabric Services is enabled in the network. Which type of IP address is used by the Cisco Fabric Services protocol?

A.

IPv4 unicast address

Answers
A.

IPv4 unicast address

B.

IPv4 multicast address

Answers
B.

IPv4 multicast address

C.

IPv4 gateway address

Answers
C.

IPv4 gateway address

D.

IPv4 anycast address

Answers
D.

IPv4 anycast address

Suggested answer: B

Explanation:

Cisco Fabric Services (CFS) utilizes IPv4 multicast addresses to disseminate configuration information across network devices. This ensures that all devices within the network have consistent and synchronized configuration data, which is crucial for maintaining the integrity and stability of the network.

Show Answer
asked 10/10/2024
rene laas
49 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms