ExamGecko
Search Search Login
Home Home / Cisco / 350-601
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibit. An engineer configures FCoE in a newly installed data center. Which configuration must be applied to activate VSAN 100 on VFC100?
Refer to the exhibit. A source is sending a multicast traffic stream to the receiver. How is the multicast traffic expected to flow through the network when it reaches a vPC peer?
Refer to the exhibit. An engineer must access a Cisco UCS C-Series server KVM from a remote location. The engineer must use the out-of-band interface to access the KYM. Which configuration set meets these requirements?
Refer to the exhibit. Refer to the exhibit. An engineer must monitor ingress traffic from SW1 and SW2 port-channel interfaces from SW3. Which configuration must be implemented to accomplish this goal? A) B) C) D)
DRAG DROP Refer to the exhibit. During a recent outage, a network engineer discovered that host A started to experience intermittent connectivity, when Leaf102 was down. Drag and drop the code snippets from the bottom onto the boxes in the code to resolve the problem. Not all code snippets are used.
Refer to the exhibit. Refer to the exhibit. What is the result of executing this python code?
What are two types of FC/FCoE oversubscription ratios? (Choose two.)
Refer to the exhibit. A network engineer must configure the physical domain and attach a VLAN pool to it. Which two commands accomplish this goal? (Choose two.)
Refer to the exhibit. A network engineer configures the VXLAN between the routers in a data center. The VLAN 10 must be extended between routers A and B. The initial VXLAN configuration is completed on RouterA. Which configuration finishes the VXLAN configuration on Router A? A. B. C. D.
Which solution provides remote and direct file-level access to users and systems?

Question 228 - 350-601 discussion

Report
Export

An engineer is configuring AAA authentication on an MDS 9000 switch. The LDAP server is located under the IP 10.10.2.2. The data sent to the LDAP server should be encrypted. Which command should be used to meet these requirements?

A.

Idap-server host 10.10.2.2 enable-ssl

Answers
A.

Idap-server host 10.10.2.2 enable-ssl

B.

Idap-server 10.10.2.2 port 443

Answers
B.

Idap-server 10.10.2.2 port 443

C.

Idap server host 10.10.2.2 key SSL_KEY

Answers
C.

Idap server host 10.10.2.2 key SSL_KEY

D.

Idap-server 10.10.2.2 key SSL_KEY

Answers
D.

Idap-server 10.10.2.2 key SSL_KEY

Suggested answer: A

Explanation:

The command ''ldap-server host 10.10.2.2 enable-ssl'' is used to configure AAA authentication on an MDS 9000 switch with an LDAP server located at the IP 10.10.2.2. This command ensures that the data sent to the LDAP server is encrypted using SSL, which is a protocol for securing network communication.

Show Answer
asked 10/10/2024
Harieswaran Ramesh
37 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms