ExamGecko
Search Search Login
Home Home / Cisco / 350-701
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Which compliance status is shown when a configured posture policy requirement is not met?
An engineer is configuring device-hardening on a router in order to prevent credentials from being seen if the router configuration was compromised. Which command should be used?
Which two features are used to configure Cisco ESA with a multilayer approach to fight viruses and malware? (Choose two)
Which two application layer preprocessors are used by Firepower Next Generation Intrusion Prevention System? (Choose two)
DRAG DROP Drag and drop the capabilities of Cisco Firepower versus Cisco AMP from the left into the appropriate category on the right.
Which Cisco platform onboards the endpoint and can issue a CA signed certificate while also automatically configuring endpoint network settings to use the signed endpoint certificate, allowing the endpoint to gain network access?
Which PKI enrollment method allows the user to separate authentication and enrollment actions and also provides an option to specify HTTP/TFTP commands to perform file retrieval from the server?
An administrator is configuring N I P on Cisco ASA via ASDM and needs to ensure that rogue NTP servers cannot insert themselves as the authoritative time source Which two steps must be taken to accomplish this task? (Choose two)
What is a characteristic of Dynamic ARP Inspection?
Which ASA deployment mode can provide separation of management on a shared appliance?

Question 109 - 350-701 discussion

Report
Export


Refer to the exhibit.

What does the number 15 represent in this configuration?

A.

privilege level for an authorized user to this router

Answers
A.

privilege level for an authorized user to this router

B.

access list that identifies the SNMP devices that can access the router

Answers
B.

access list that identifies the SNMP devices that can access the router

C.

interval in seconds between SNMPv3 authentication attempts

Answers
C.

interval in seconds between SNMPv3 authentication attempts

D.

number of possible failed attempts until the SNMPv3 user is locked out

Answers
D.

number of possible failed attempts until the SNMPv3 user is locked out

Suggested answer: B

Explanation:

The syntax of this command is shown below: snmp-server group [group-name {v1 | v2c | v3 [auth | noauth | priv]}] [read read-view] [write writeview] [notify notify-view] [access access-list] The command above restricts which IP source addresses are allowed to access SNMP functions on the router. You could restrict SNMP access by simply applying an interface ACL to block incoming SNMP packets that don't come from trusted servers. However, this would not be as effective as using the global SNMP commands shown in this recipe. Because you can apply this method once for the whole router, it is much simpler than applying ACLs to block SNMP on all interfaces separately. Also, using interface

ACLs would block not only SNMP packets intended for this router, but also may stop SNMP packets that just happened to be passing through on their way to some other destination device.

Show Answer
asked 10/10/2024
Roger Warner
33 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms