ExamGecko
Search Search Login
Home Home / Cisco / 350-701
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Which compliance status is shown when a configured posture policy requirement is not met?
An engineer is configuring device-hardening on a router in order to prevent credentials from being seen if the router configuration was compromised. Which command should be used?
Which two features are used to configure Cisco ESA with a multilayer approach to fight viruses and malware? (Choose two)
Which two application layer preprocessors are used by Firepower Next Generation Intrusion Prevention System? (Choose two)
DRAG DROP Drag and drop the capabilities of Cisco Firepower versus Cisco AMP from the left into the appropriate category on the right.
Which Cisco platform onboards the endpoint and can issue a CA signed certificate while also automatically configuring endpoint network settings to use the signed endpoint certificate, allowing the endpoint to gain network access?
Which PKI enrollment method allows the user to separate authentication and enrollment actions and also provides an option to specify HTTP/TFTP commands to perform file retrieval from the server?
An administrator is configuring N I P on Cisco ASA via ASDM and needs to ensure that rogue NTP servers cannot insert themselves as the authoritative time source Which two steps must be taken to accomplish this task? (Choose two)
What is a characteristic of Dynamic ARP Inspection?
Which ASA deployment mode can provide separation of management on a shared appliance?

Question 111 - 350-701 discussion

Report
Export

Refer to the exhibit.

A network administrator configures command authorization for the admin5 user. What is the admin5 user able to do on HQ_Router after this configuration?

A.

set the IP address of an interface

Answers
A.

set the IP address of an interface

B.

complete no configurations

Answers
B.

complete no configurations

C.

complete all configurations

Answers
C.

complete all configurations

D.

add subinterfaces

Answers
D.

add subinterfaces

Suggested answer: B

Explanation:

The user "admin5" was configured with privilege level 5. In order to allow configuration (enter global configuration mode), we must type this command:

(config)#privilege exec level 5 configure terminal

Without this command, this user cannot do any configuration.

Note: Cisco IOS supports privilege levels from 0 to 15, but the privilege levels which are used by default are privilege level 1 (user EXEC) and level privilege 15 (privilege EXEC)

Show Answer
asked 10/10/2024
Janina Loveria
39 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms