ExamGecko
Search Search Login
Home Home / Cisco / 350-801
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Where is urgent priority enabled to bypass the T302 timer?
An administrator must implement toll fraud prevention on Cisco UCM using these parameters: • Enable Forced Authorization Code 112211. • Set an authorization level of 3 for the route pattern 8005551212. • Require no access code to dial 10-digit numbers. How must the route pattern be implemented?
An engineer troubleshoots outbound can failure on an ISDN-PRI circuit. The engineer ts suspecting the 'Incomplete Destination". Which debugs or commands are run in the voice gateway to troubleshoot the issue?
An administrator must configure the Local Route Group feature on Cisco UCM. Which step will enable this feature?
Which two parameters influence the total number of supported conference participants on a Cisco IOS XE router that has DSP modules? (Choose two.)
An administrator must make a pattern to route calls to two different destinations john doe@company com and jane doe@company com Which type of patterns are needed in the Cisco UCM. and what must the pattern look like?
What are two Cisco UCM location bandwidths that are deducted when G 729 and G.711 codecs are used? (Choose two.)
An administrator is configuring a new Cisco UCM with PSTN capabilities. Due to bandwidth constraints, audio compression is used on the codec. DTMF must work as expected because the customer is calling many call centers where the users must select options in the call. Where is DTMF out-of-band in a CCM 12.5 with SIP-based gateway configured?
An engineer must configure a route pattern that can route all + E.164 globalized international numbers for the dial plans of all countries. Which cisco UCM configuration accomplishes this task?
A Cisco Telepresence SX80 suddenly has issues displaying main video to a display over HDMI. Which command can you use from the SX80 admin CLI to check the video output status to the monitor?

Question 174 - 350-801 discussion

Report
Export

An administrator is integrating a Cisco Unity Express module to a Cisco UCME system A test call is placed to the Cisco Unity Express pilot number, but the administrator receives a busy signal. The dialpeer is configured as follows:

dial-peer voice 4100 voip

destination-pattern 41..

session protocol sipv2

session target ipv4:10.1.10.1

dtmf-relay sip-notify no vad

How is this issue resolved?

A.

The dial-peer needs to be reconfigured to support the G.711 voice codec.

Answers
A.

The dial-peer needs to be reconfigured to support the G.711 voice codec.

B.

The dial-peer needs to be reconfigured to support vad.

Answers
B.

The dial-peer needs to be reconfigured to support vad.

C.

The destination pattern needs to be changed to match the dialed number of 4100.

Answers
C.

The destination pattern needs to be changed to match the dialed number of 4100.

D.

The dial-peer needs to be reconfigured to support H 323 instead of SIP.

Answers
D.

The dial-peer needs to be reconfigured to support H 323 instead of SIP.

Suggested answer: A
Show Answer
asked 10/10/2024
Matt Gifford
33 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms