ExamGecko
Search Search Login
Home Home / Cisco / 350-801
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Where is urgent priority enabled to bypass the T302 timer?
An administrator must implement toll fraud prevention on Cisco UCM using these parameters: • Enable Forced Authorization Code 112211. • Set an authorization level of 3 for the route pattern 8005551212. • Require no access code to dial 10-digit numbers. How must the route pattern be implemented?
An engineer troubleshoots outbound can failure on an ISDN-PRI circuit. The engineer ts suspecting the 'Incomplete Destination". Which debugs or commands are run in the voice gateway to troubleshoot the issue?
Which two parameters influence the total number of supported conference participants on a Cisco IOS XE router that has DSP modules? (Choose two.)
An administrator must configure the Local Route Group feature on Cisco UCM. Which step will enable this feature?
What are two Cisco UCM location bandwidths that are deducted when G 729 and G.711 codecs are used? (Choose two.)
An engineer must configure a route pattern that can route all + E.164 globalized international numbers for the dial plans of all countries. Which cisco UCM configuration accomplishes this task?
Why would we not include an end user's PC device in a QoS trust boundary?
Which actions required for a firewall configuration on a Mobile and Remote Access through Cisco Expressway deployment?
An administrator must make a pattern to route calls to two different destinations john doe@company com and jane doe@company com Which type of patterns are needed in the Cisco UCM. and what must the pattern look like?

Question 448 - 350-801 discussion

Report
Export

Refer to the exhibit.


A call is falling to establish between two SIP Devices The called device answers with these SOP Which

SOP parameter causes issue?

A.

The calling device did not offer a ptime value

Answers
A.

The calling device did not offer a ptime value

B.

The media stream is set to send only

Answers
B.

The media stream is set to send only

C.

The payload for G.711ulaw must be 18.

Answers
C.

The payload for G.711ulaw must be 18.

D.

The RTP port is set to 0.

Answers
D.

The RTP port is set to 0.

Suggested answer: D

Explanation:

The RTP port is used to send and receive media packets during a call. If the RTP port is set to 0, the called device will not be able to send or receive media packets, and the call will fail.

The other options are not correct because:

A. The calling device did not offer a ptime value: The ptime value is used to specify the amount of time between each media packet. If the calling device does not offer a ptime value, the called device will use the default value of 20 milliseconds.

B. The media stream is set to sendonly: The media stream is set to sendonly when the called device is only able to send media packets, and not receive them. This is not a problem, and the call will still

succeed.

C. The payload for G.711ulaw must be 18: The payload for G.711ulaw is the type of media packet

that is used. The payload must be set to 18 for G.711ulaw, but this is not a problem, and the call will

still succeed.

Show Answer
asked 10/10/2024
BISWARUP KUNDU
41 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms