Home

Home / HP / HPE6-A85

Question list

List of questions

Question 1

(0)

You put in a few show commands on switches EDGE1 and CORE1 to attempt to gather information to troubleshoot the issue Use the show command output images to determine the reason for the EDGE1 uplink

Question 2

(0)

What can be done to dynamically set the PoE Priority on a switch port when deploying IP cameras APs. and other PoE devices?

Question 3

(0)

Which Protocol Data Unit (PDU) represents the data link layer PDU?

Question 4

(0)

What is an advantage of using Layer 2 MAC authentication?

Question 5

(0)

When using Aruba Central what can identify recommended steps to resolve network health issues and allows you to share detailed information with support personnel?

Question 6

(0)

Which statement is true for a device with a MAC address of B8-31-B5-80-41-4F?

Question 7

(0)

A network technician is using Aruba Central to troubleshoot network issues Which dashboard can be used to view and acknowledge issues when beginning the troubleshooting process?

Question 8

(0)

Based on the given topology, what is the requirement on an Aruba switch to enable LLDP messages to be received by Switch 1 port 1/1/24. when Router 1 is enabled with LLDP?

Question 9

(0)

You are in a meeting with a customer where you are asked to explain the network redundancy feature Multiple Spanning Tree (MSTP). What is the correct statement for this feature?

Question 10

(0)

When using the OSPF dynamic routing protocol on an Aruba CX switch, what must match on the neighboring devices to exchange routes?

Open VPLUS File

Convert VPLUS to PDF

Related questions

How does a single Aruba CX 6300M switch configuration use L3 connectivity to establish routing traffic between switch virtual interfaces 120 and 130?

You are in a meeting with a customer where you are asked to explain the network redundancy feature Multiple Spanning Tree (MSTP). What is the correct statement for this feature?

DRAG DROP Match each AAA service with its correct definition (Matches may be used more than once or not at all)

What does a slow amber-flashing Stack-LED indicate?

What are the main characteristics of the 6 GHz band?

Which device configuration group types can a user define in Aruba Central during group creation? (Select two.)

Which part of the WPA Key Hierarchy is used to encrypt and/or decrypt data''

Which commands are used to set a default route to 10.4.5.1 on an Aruba CX switch when ln-band management using an SVl is being used?

What can be done to dynamically set the PoE Priority on a switch port when deploying IP cameras APs. and other PoE devices?

You need to troubleshoot an Aruba CX 6200 4-node VSF stack switch that fails to boot correctly Select the option that allows you to access the switch and see the boot options available for OS images and ServiceOS.

Question 48 - HPE6-A85 discussion

Report

When would you bond multiple 20MHz wide 802.11 channels?

A.

To decrease the Signal to Noise Ratio (SNR)

B.

To increase throughput between the client and AP

C.

To provision highly available AP groups

D.

To utilize high gain omni-directional antennas

Show Answer

asked 16/09/2024

nosh shah

43 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first