Home

Home / HP / HPE7-A01

Question list

List of questions

Question 1

(0)

Which statements regarding Aruba NAE agents are true? (Select two )

Question 2

(0)

What is an OSPF transit network?

Question 3

(0)

Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).

Question 4

(0)

A network administrator is troubleshooting some issues guest users are having when connecting and authenticating to the network The access switches are AOS-CX switches. What command should the admi

Question 5

(0)

Using Aruba best practices what should be enabled for visitor networks where encryption is needed but authentication is not required?

Question 6

(0)

Which statements are true about VSX LAG? (Select two.)

Question 7

(0)

What steps are part of the Key Management workflow when a wireless device is roaming from AP1 to AP2? (Select two.)

Question 8

(0)

What are two advantages of splitting a larger OSPF area into a number of smaller areas? (Select two )

Question 9

(0)

The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message is being sent to t

Question 10

(0)

DRAG DROP What is the order of operations tor Key Management service for a wireless client roaming from AP1 to AP2?

Open VPLUS File

Convert VPLUS to PDF

Related questions

Which component is used by the Aruba Network Analytics Engine (NAE)?

Which standard supported by some Aruba APs can enable a customer to accurately locate wireless client devices within a few meters?

Your customer currently has Iwo (2) 5406 modular switches with MSTP configured as their core switches. You are proposing a new solution. What would you explain regarding the Aruba CX VSX switch pair when the Primary VSX node is replaced and the system MAC is replaced?

For an Aruba AOS10 AP in mixed mode, which factors can be used to determine the forwarding role assigned to a client? (Select two.)

For the Aruba CX 6400 switch, what does virtual output queueing (VOQ) implement that is different from most typical campus switches?

You need to drop excessive broadcast traffic on an ingress port or an ArubaOS-CX switch. What is the best feature to use for this task?

A customer just upgraded aggregation layer switches and noticed traffic dropping for 120 seconds after the aggregation layer came online again. What is the best way to avoid having this traffic dropped given the topology below?

You are doing tests in your lab and with the following equipment specifications: * AP1 has a radio that generates a 20 dBm signal * AP2 has a radio that generates a 8 dBm signal * AP1 has an antenna with a gain of 7 dBI. * AP2 has an antenna with a gain of 12 dBI. * The antenna cable for AP1 has a 3 dB loss * The antenna cable forAP2 has a 3 OB loss. What would be the calculated Equivalent Isotropic Radiated Power (EIRP) for AP1?

When configuring UBT on a switch what will happen when a gateway role is not specified?

Which statements regarding 0SPFv2 route redistribution are true for Aruba OS CX switches? (Select two.)

Question 38 - HPE7-A01 discussion

Report

With the Aruba CX switch configuration, what is the first-hop protocol feature that is used for VSX L3 gateway as per Aruba recommendation?

A.

Active Gateway

B.

Active-Active VRRP

C.

SVI with vsx-sync

D.

VRRP

Show Answer

asked 16/09/2024

Peter Stones

39 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first