Home / HP / HPE7-A01

Question list

List of questions

Question 1

(0)

Which statements regarding Aruba NAE agents are true? (Select two )

Question 2

(0)

What is an OSPF transit network?

Question 3

(0)

Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).

Question 4

(0)

A network administrator is troubleshooting some issues guest users are having when connecting and authenticating to the network The access switches are AOS-CX switches. What command should the admi

Question 5

(0)

Using Aruba best practices what should be enabled for visitor networks where encryption is needed but authentication is not required?

Question 6

(0)

Which statements are true about VSX LAG? (Select two.)

Question 7

(0)

What steps are part of the Key Management workflow when a wireless device is roaming from AP1 to AP2? (Select two.)

Question 8

(0)

What are two advantages of splitting a larger OSPF area into a number of smaller areas? (Select two )

Question 9

(0)

The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message is being sent to t

Question 10

(0)

DRAG DROP What is the order of operations tor Key Management service for a wireless client roaming from AP1 to AP2?

Question 53 - HPE7-A01 discussion

You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new default route to 10.1.1.253. Other non-default routes for this subnet should not be affected by this change.

What are two parts of the solution for these requirements? (Select two.)

Option A

Option B

Option C

Option D

Option E

Suggested answer: C, E

Explanation:

Two parts of the solution for these requirements are Option C and Option E.

Option C is a part of the solution because it defines a policy-based routing action list named route_test, which specifies the next hop IP address as 10.1.1.253 for the matching traffic. This is the new default route that the user wants to use for the subnet 10.2.250.0/24. The interface null parameter indicates that the traffic will be routed to the next hop without using a specific interface1.

Option E is a part of the solution because it applies the policy-based routing action list route_test to the VLAN interface 250, which has an IP address of 10.2.250.1/24. This is the subnet that the user wants to test the new default route for. The apply policy command enables policy-based routing on the interface and associates it with the action list2.

Option A is not a part of the solution because it defines a policy-based routing action list named route_test, but does not specify the next hop IP address as 10.1.1.253, which is the new default route that the user wants to use. Instead, it specifies a next hop IP address of 10.1.1.254, which is different from the requirement.

Option B is not a part of the solution because it defines a policy-based routing action list named route_test, but does not specify any next hop IP address at all, which is necessary for policy-based routing to work. Instead, it specifies an interface null parameter without any IP address, which is invalid.

Option D is not a part of the solution because it applies the policy-based routing action list route_test to the VLAN interface 200, which has an IP address of 10.2.200.1/24. This is not the subnet that the user wants to test the new default route for, but a different subnet that should not be affected by this change.

Show Answer

asked 16/09/2024

Kamil Stonjek

36 questions

Your answer: A B C D E

0 comments

Sorted by