Home

Home / DELL / D-SNC-DY-00

Question list

List of questions

Question 1

(0)

SIMULATION Use the simulator to perform the following configuration task. 1. Map a single-tagged CVLAN 100 to SVLAN 200 translation on PE switch interface Eth1/1. 2. Map a double-tagged VLAN pac

Question 2

(0)

SIMULATION Create port channel 10 on interfaces Eth 1/11 and 1/12, so that it connects to an already configured switch. A server will be connected on Eth 1/1. Both the server and port channel need

Question 3

(0)

SIMULATION VLAN 40 is configured in Switch A with an anycast-address of 192.168.40.254/24. The ARP neighbor suppression is enabled. Use the simulator to create a VTEP named vtep1 and assign an IP a

Question 4

(0)

SIMULATION A customer must configure a peer link between two switches in the L2 MC-LAG scenario. SwitchB has already been configured. Configure the peer link on SwitchA. Use the following configu

Question 5

(0)

SIMULATION Configure a VRF called 'VrfGreen' and the static route in it to network 172.16.128.64/28 through next-hop 10.10.10.1. Set an administrative distance of 213.

Question 6

(0)

DRAG DROP In what order should these commands be entered to configure an access port in SONiC CLI if the required VLAN is already configured?

Question 7

(0)

Refer to the exhibit. What can be determined from this show command?

Question 8

(0)

How many port channels can be assigned to a single port?

Question 9

(0)

Which two elements must be included in the show mclag interface x x command?

Question 10

(0)

What are three characteristics of VLAN translation?

Open VPLUS File

Convert VPLUS to PDF

Related questions

DRAG DROP What is the correct order of steps for data flow in asymmetric IRB frame encapsulation?

Refer to the exhibit. What is the primary VRRP router for VRRP group 10?

An administrator for a service provider uses this command on a switch: What is the result of running the command?

Which network devices route unencapsulated user traffic in a symmetric IRB overlay network?

What is a correct use-case scenario for ZTP in Enterprise SONiC?

An administrator obtains the following CLI output: How much time does the local system take to detect remote failures without receiving packets?

What does the show vian command display?

Which two additional Q-in-Q VLAN tunnel configuration steps must be followed if the provider network uses a VXLAN overlay?

Which two elements are configured when RoCE is enabled?

SIMULATION Configure a VRF called 'VrfGreen' and the static route in it to network 172.16.128.64/28 through next-hop 10.10.10.1. Set an administrative distance of 213.

Question 35 - D-SNC-DY-00 discussion

Report

What is the purpose of the write erase boot command option?

A.

Delete the startup and enable zero touch provisioning.

B.

Remove user-installed packages and tile changes.

C.

Delete the startup configuration and the management interface configuration.

D.

Delete the running configuration and all user accounts.

Show Answer

asked 16/09/2024

Petya Pavlova

43 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first