ExamGecko
Search Search Login
Home Home / DELL / D-VXR-OE-23
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

SIMULATION During a maintenance task on a VxRail Appliance, the system LED on vcluster730-esx03.edu.local is required to be enabled so the node can be correctly identified in the physical rack. Use the simulator to enable the System LED for the node.
SIMULATION Task An administrator is working with the VxRail Dell Support team and as part of the troubleshooting, the admin has been instructed to temporarily remove the node with a serial number of 'V0730040000000' from the cluster. User credentials are Username of '[email protected]' Password 'VMw@r3!123'. Using the simulator, identify the correct node and remove it from the cluster.
For how long is the vSAN Health history of the VxRail system stored?
SIMULATION VxRail administrator got the following warning while on node physical view. 'Health monitoring is currently disabled and information may not be accurate. Dell recommends that health monitoring is enabled.' Use the simulator to enable the relevant service and resolve the issue.
When the VxRail cluster is deployed, what vSAN storage policy settings are applied to the VxRail Manager VIVP
What is required to setup vSAN HCI Mesh?
A VxRail Cluster has been deployed with four VxRail E560 nodes each using tour integrated NIC ports and the default network profile. Which vmnics carry the VxRail management traffic, and in what teaming and failover configuration?
Which command is used to unlock the mystic account on the VxRail Manager VM?
An administrator must shut down a VxRail cluster However the validation process has failed and cannot be completed What action must be taken to correct the issue?
An environment has two VxRail clusters In vCenter there is only one vSphere Distributed Switch object for both clusters Which deployment architecture was used for these clusters?

Question 40 - D-VXR-OE-23 discussion

Report
Export

An administrator needs to place a node in maintenance mode They want to ensure vSAN does not start rebuilding absent components during the time it takes for maintenance to be completed

What would allow the administrator to achieve this?

A.
Temporarily disable components ^synchronization.
Answers
A.
Temporarily disable components ^synchronization.
B.
Temporarily set FTT=0 in vSAN Storage Policy.
Answers
B.
Temporarily set FTT=0 in vSAN Storage Policy.
C.
Increase vSAN Object repair timer
Answers
C.
Increase vSAN Object repair timer
D.
Increase durability component lifetime.
Answers
D.
Increase durability component lifetime.
Suggested answer: C

Explanation:

To ensure that vSAN does not start rebuilding absent components while a node is in maintenance mode, an administrator should increase the vSAN Object repair timer. The Object repair timer controls the delay before vSAN initiates the rebuild of absent components. By increasing this timer, the administrator can ensure that maintenance can be completed without triggering unnecessary rebuilds, reducing the load on the system and preventing potential data redundancy issues.

VMware vSAN Configuration Guide: vSAN Configuration Guide

Show Answer
asked 16/09/2024
MARCONDES SANTOS
34 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms