Question 19 - D-XTR-DY-A-24 discussion

To create an iSCSI portal using the XtremIO X2 XMS WebUI, an administrator would start the configuration process in the ''Configuration'' section. Here's how the process typically unfolds:

Log into XMS WebUI: The administrator logs into the XtremIO Management Server (XMS) Web User Interface (WebUI).

Navigate to Configuration: Within the WebUI, the administrator navigates to the ''Configuration'' tab. This section contains settings and options for managing and configuring the storage array.

Access iSCSI Options: Under the ''Configuration'' tab, the administrator locates the options for iSCSI settings. This may involve expanding menus or selecting specific sub-options related to iSCSI.

Create iSCSI Portal: Once in the iSCSI settings area, the administrator can create a new iSCSI portal. This involves specifying details such as IP addresses, port numbers, and access controls.

Save and Apply: After entering all necessary information, the administrator saves the configuration and applies it to make the iSCSI portal active.

Verify Connectivity: Finally, the administrator verifies that the iSCSI portal is functioning correctly by connecting to it from an iSCSI initiator.

For detailed instructions and best practices, always refer to the official Dell XtremIO Deploy Achievement document1. This document provides comprehensive guidance on all aspects of setting up and managing XtremIO X2 arrays, including the creation of iSCSI portals.