Home

Home / DELL / D-XTR-DY-A-24

Question list

List of questions

Question 1

(0)

A systems administrator wants to add an XtremlO cluster to their VPLEX environment. Which activity must the administrator perform first?

Question 2

(0)

What is a specific configuration guideline that should be followed when configuring Linux hosts to support XtremIO storage?

Question 3

(0)

A four X-Brick XtremlO X1 cluster was installed in a customer's data center. In order to adequately supply power to all PDUs to this cluster, how many PDPs need to be connected to an electrical sour

Question 4

(0)

A systems administrator has been informed that a new backup policy has been put in place for 500 production volumes on an XtremIO X2-R array. The 500 production volumes must be backed up four times

Question 5

(0)

In a heterogeneous environment, what is a recommended setting when multiple storage arrays are connected to VMware vSphere in addition to XtremIO X2?

Question 6

(0)

If a systems administrator needs to create a new XtremlO report, what is the minimum account role required?

Question 7

(0)

What is an accurate statement regarding RecoverPoint and XtremIO?

Question 8

(0)

A company requires hourly snapshots to be taken from a set of 15 volumes. Assuming no other volumes or snapshots exist, approximately how long can an XtremIO X1 array continue to fulfill this reques

Question 9

(0)

A new XtremlO X2-S single X-Brick cluster has been installed into a systems administrator's environment. The administrator needs assistance with configuring a group of volumes with the largest capac

Question 10

(0)

What should be done prior to presenting XtremlO volumes to a new Linux host?

Open VPLUS File

Convert VPLUS to PDF

Related questions

When deploying Connect Home using FTPS at the customer site, which TCP ports must be open between the XMS and the Dell Technologies FTP server?

A systems administrator is powering up a XtremIO X2 multi X-Brick cluster. Which components will automatically power-up when the rack PDUs are turned on?

Refer to the exhibit. When an XtremIO X2 array is delivered, where is the cable shown in the exhibit connected?

In an XtremIO X2-R four X-Brick cluster, how many total rack units should be left for the Cable Management ducts?

If a systems administrator needs to create a new XtremlO report, what is the minimum account role required?

Which XtremlO XMCLI command can be used to test the Connect Home functionality?

A new XtremlO X2-S single X-Brick cluster has been installed into a systems administrator's environment. The administrator needs assistance with configuring a group of volumes with the largest capacity possible. What is the largest size supported for each volume?

A company requires hourly snapshots to be taken from a set of 15 volumes. Assuming no other volumes or snapshots exist, approximately how long can an XtremIO X1 array continue to fulfill this request until the system maximum is reached?

What is an accurate statement regarding RecoverPoint and XtremIO?

In a heterogeneous environment, what is a recommended setting when multiple storage arrays are connected to VMware vSphere in addition to XtremIO X2?

Question 41 - D-XTR-DY-A-24 discussion

Report

You are filling out the Site Preparation form for an XtremlO X2 two X-Brick system installation. Why are only two IP addresses required?

A.

A form from an X1 installation was used

B.

X2 systems are managed only through odd numbered X-Bricks

C.

X2 systems are managed through only the first X-Brick

D.

Second X-Brick assumes the addresses if the first X-Brick fails over

Show Answer

asked 16/09/2024

Min Soe Aye

40 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first