Refer to the exhibit.
The exhibit shows a diagram of a FortiGate device connected to the network and the firewall policy and IP pool configuration on the FortiGate device.
Two PCS, PCI and PC2, are connected behind FortiGate and can access the internet successfully. However, when the administrator adds a third PC to the network (PC3), the PC cannot connect to the Intarnet_
Based on the information shown in the exhibit, which three configuration changes should the administrator make to fix the connectivity issue for PC3? (Choose three.)

Question

Refer to the exhibit.The exhibit shows a diagram of a FortiGate device connected to the network and the firewall policy and IP pool configuration on the FortiGate device.Two PCS, PCI and PC2, are connected behind FortiGate and can access the internet successfully. However, when the administrator adds a third PC to the network (PC3), the PC cannot connect to the Intarnet_Based on the information shown in the exhibit, which three configuration changes should the administrator make to fix the connectivity issue for PC3? (Choose three.)

Aurelio Chavez · Accepted Answer

In the IP pool configuration, set type to overload.

Aurelio Chavez · Accepted Answer

In the IP pool configuration, set endip to 192.2. O .12

Aurelio Chavez · Accepted Answer

In the firewall policy configuration, disable ippool.

Aurelio Chavez · Answer

Configure 192.2. O. 12/24 as the secondary IP address on port1

Aurelio Chavez · Answer

Configure another firewall policy that matches only the address of PC3 as source, and then place the policy on top of the list.

Question list

List of questions

Question 1

(0)

Question 2

(0)

Question 3

(0)

Question 4

(0)

Question 5

(0)

Question 6

(0)

Question 7

(0)

Question 8

(0)

Question 9

(0)

Question 10

(0)

Related questions

Question 178 - NSE4_FGT-7.2 discussion

Suggested answer: A, D, E

0 comments