In a network, the same gigabit running S and OSPF anti-tampering and fluttering as shown in the figure, on the two border routers RTB and RTC are introduced into the wine route, the device question is to use gigabit one port strobe, , 222 The network is introduced into the OSE via impotrote direct on the RTD, assuming that all other configurations are dead default configurations, then the description of this network is wrong ?

Question

In a network, the same gigabit running S and OSPF anti-tampering and fluttering as shown in the figure, on the two border routers RTB and RTC are introduced into the wine route, the device question is to use gigabit one port strobe, , 222 The network is introduced into the OSE via impotrote direct on the RTD, assuming that all other configurations are dead default configurations, then the description of this network is wrong ?

Innos Phoku · Accepted Answer

On the RTC, the following configuration is adopted, only the routes of the 2222/32 cinder segment can be filtered out when routing is introduced, IRTClip ip-prefix 10 index 1 deny2000 8 lessequal 32

Innos Phoku · Answer

Adjusting the ISIS priority to 160 on the RTB avoids suboptimal routing problems in the network.

Innos Phoku · Answer

RTB learns that the routing next hop for the 2222/32 network segment is RTA

Innos Phoku · Answer

The following configuration can filter out the routes of the 2222/32 CIDR block of the white RTD when RTC introduces OSPF routes.

Question list

List of questions

Question 1

(0)

Question 2

(0)

Question 3

(0)

Question 4

(0)

Question 5

(0)

Question 6

(0)

Question 7

(0)

Question 8

(0)

Question 9

(0)

Question 10

(0)

Related questions

Question 418 - H12-891 discussion

Suggested answer: B

0 comments