ExamGecko
Search Search Login
Home Home / Huawei / H31-311
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Forced switching, fiber cut switching, manual switching, and exercise switching are in the descending order of priority.
Which of the following is the multiplexing mode of SDH?
The last 256 columns in the OTN frame structure are FEC areas, which are used for forward error correction.
OTM nr.m consists of a maximum of 'n' optical multiplexing channels and does not support non-channel-associated overheads. The letter 'r' indicates function reduction.
Both PDH and SDH have globally unified standards.
MAC loopback and PHY loopback are used for fault locating. When the MAC loopback is set to an inloop, you can set the PHY loopback according to the actual situation.
On the NMS, the NE performance monitoring time is set to () minutes and () hours,
When the ACT indicator of an SDH board is off, it indicates that this board has a hardware fault and cannot be used,
Which of the following ITU-T recommendations defines the OTN frame structure?
When a bridge uses the IVL learning mode, the entry in the MAC address table is created according to the source MAC address and source port of the data frame. This entry is valid for all VLANs.

Question 64 - H31-311 discussion

Report
Export

Which of the following statements about an MSP ring are correct? (Multiple Choice)

A.
The number of nodes on an MSP ring cannot exceed 16.
Answers
A.
The number of nodes on an MSP ring cannot exceed 16.
B.
When creating a protection subnet, select SDH NEs only. Do not select REG or WDM NEs.
Answers
B.
When creating a protection subnet, select SDH NEs only. Do not select REG or WDM NEs.
C.
When multiple protection subnets occupy the same port on the same board, you must select 'Resource Sharing'.
Answers
C.
When multiple protection subnets occupy the same port on the same board, you must select 'Resource Sharing'.
D.
'Assigned by VC4' means that different VC4s are assigned to different protection subnets to achieve MSP only in some channels.
Answers
D.
'Assigned by VC4' means that different VC4s are assigned to different protection subnets to achieve MSP only in some channels.
Suggested answer: A, B, C, D
Show Answer
asked 18/09/2024
Angelo Gulisano
36 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms