ExamGecko
Search Search Login
Home Home / Huawei / H31-311
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Forced switching, fiber cut switching, manual switching, and exercise switching are in the descending order of priority.
Which of the following is the multiplexing mode of SDH?
The last 256 columns in the OTN frame structure are FEC areas, which are used for forward error correction.
OTM nr.m consists of a maximum of 'n' optical multiplexing channels and does not support non-channel-associated overheads. The letter 'r' indicates function reduction.
Both PDH and SDH have globally unified standards.
MAC loopback and PHY loopback are used for fault locating. When the MAC loopback is set to an inloop, you can set the PHY loopback according to the actual situation.
On the NMS, the NE performance monitoring time is set to () minutes and () hours,
When the ACT indicator of an SDH board is off, it indicates that this board has a hardware fault and cannot be used,
Which of the following ITU-T recommendations defines the OTN frame structure?
When a bridge uses the IVL learning mode, the entry in the MAC address table is created according to the source MAC address and source port of the data frame. This entry is valid for all VLANs.

Question 98 - H31-311 discussion

Report
Export

When a working PQ1 board is faulty, the device performs TPS protection switching. Which of the following statements about the switching process are correct? (Multiple Choice)

A.
The cross-connect board detects that the PQ1 board is faulty through the board status bus.
Answers
A.
The cross-connect board detects that the PQ1 board is faulty through the board status bus.
B.
If the protection PQ1 board is normal, the cross-connect board sends a switching message to the D75S corresponding to the faulty PQ1 board through the switching control bus.
Answers
B.
If the protection PQ1 board is normal, the cross-connect board sends a switching message to the D75S corresponding to the faulty PQ1 board through the switching control bus.
C.
The D75S board responds to the switching message by transferring services to the shared protection bus and stopping sending services to the faulty PQ1 board.
Answers
C.
The D75S board responds to the switching message by transferring services to the shared protection bus and stopping sending services to the faulty PQ1 board.
D.
The protection PQ1 board receives and processes the services that are transferred from the D75S board to the protection bus to complete the protection switching.
Answers
D.
The protection PQ1 board receives and processes the services that are transferred from the D75S board to the protection bus to complete the protection switching.
Suggested answer: A, B, C, D
Show Answer
asked 18/09/2024
Nosh Shah
37 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms