You have just brought online a new site of AP43s. While verifying that everything looks good, you notice that all of the access points (APs) are reporting "insufficient power." The APs are connected to an 802. 3at-capable switch.
In this scenario, what would be the cause of the error?

Question

You have just brought online a new site of AP43s. While verifying that everything looks good, you notice that all of the access points (APs) are reporting "insufficient power." The APs are connected to an 802. 3at-capable switch.

In this scenario, what would be the cause of the error?

Tural Pashayev · Accepted Answer

LLDP-MED is not configured on the switch.

Tural Pashayev · Answer

The cable run to each AP is too long.

Tural Pashayev · Answer

The Ethernet cable is plugged into the wrong port on the AP.

Tural Pashayev · Answer

The APs' firmware must be upgraded.

Question list

List of questions

Question 1

(0)

Question 2

(0)

Question 3

(0)

Question 4

(0)

Question 5

(0)

Question 6

(0)

Question 7

(0)

Question 8

(0)

Question 9

(0)

Question 10

(0)

Related questions

Question 77 - JN0-251 discussion

Suggested answer: D

0 comments