Home

Home / Juniper / JN0-351

Question list

List of questions

Question 1

(0)

Exhibit. Which router will become the OSPF BDR if all routers are powered on at the same time?

Question 2

(0)

Exhibit. What is the management IP address of the device shown in the exhibit?

Question 3

(0)

Which three protocols support BFD? (Choose three.)

Question 4

(0)

Exhibit. The ispi _ inet. 0 route table has currently no routes in it. What will happen when you commit the configuration shown on the exhibit?

Question 5

(0)

Which statement is correct about graceful Routing Engine switchover (GRES)?

Question 6

(0)

Which statement is correct about controlling the routes installed by a RIB group?

Question 7

(0)

Exhibit. You are using OSPF to advertise the subnets that are used by the Denver and Dallas offices. The routers that are directly connected to the Dallas and Denver subnets are not advertising t

Question 8

(0)

Exhibit. You want to verify prefix information being sent from 10.36.1.4. Which two statements are correct about the output shown in the exhibit? (Choose two.)

Question 9

(0)

What is the default keepalive time for BGP?

Question 10

(0)

Which two statements are correct about tunnels? (Choose two.)

Open VPLUS File

Convert VPLUS to PDF

Related questions

Exhibit. You are using OSPF to advertise the subnets that are used by the Denver and Dallas offices. The routers that are directly connected to the Dallas and Denver subnets are not advertising the connected subnets. Referring to the exhibit, which two statements are correct? (Choose two.)

What is the default keepalive time for BGP?

Which statement about aggregate routes is correct?

In RSTP, which three port roles are associated with the discarding state? (Choose three.)

Exhibit. You want to verify prefix information being sent from 10.36.1.4. Which two statements are correct about the output shown in the exhibit? (Choose two.)

Exhibit. The ispi _ inet. 0 route table has currently no routes in it. What will happen when you commit the configuration shown on the exhibit?

Exhibit Which command displays the output shown in the exhibit?

An update to your organization's network security requirements document requires management traffic to be isolated in a non-default routing-instance. You want to implement this requirement on your Junos-based devices. Which two commands enable this behavior? (Choose two.)

You have DHCP snooping enabled but no entries are automatically created in the snooping database for an interface on your EX Series switch. What are two reasons for the problem? (Choose two.)

You are a network operator who wants to add a second ISP connection and remove the default route to the existing ISP You decide to deploy the BGP protocol in the network. What two statements are correct in this scenario? (Choose two.)

Question 43 - JN0-351 discussion

Report

What is the default MAC age-out timer on an EX Series switch?

A.

30 minutes

B.

30 seconds

C.

300 minutes

D.

300 seconds

Show Answer

asked 18/09/2024

Rumen Zazyov

33 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first