ExamGecko
Search Search Login
Home Home / Juniper / JN0-682
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

You are troubleshooting an L3VPN that is part of an EVPN/MPLS DCI. You notice that the EVPN overlay BGP session toward 10.29.50.4 is unable to establish. Why is the BGP session failing to establish?
Refer to the exhibit. Referring to the exhibit, which two statements are correct? (Choose two.)
Which two statements about a DHCP relay in an EVPN-VXLAN fabric are correct? (Choose two.)
Which two statements are true Virtual Chassis? (Choose two.)
Which two combinations are supported when configuring a Virtual Chassis Fabric? (Choose two.)
Which protocol is used between VCF member devices to create a loop-free topology?
Referring to the exhibit, each node in the IP fabric is peering to its directly attached neighbor using EBGP. Each node is peering using physical interface IP addresses. Leaf 2 and Leaf 3 are advertising the 10.1.1/24 network into EBGP. Spine 2 must be configured so that it can load- share traffic destined to the 10 1.1/24 network over both next-hop A and next-hop B. Which two actions must be performed to accomplish this task? (Choose two.)
You are asked to enable plug-and-play line card switches in an active VCF without making any future Junos configuration charges. You are also required to ensure that all new line card are automatically upgrade to the correct Junos version without any manual intervention. In this scenario, which two actions will accomplish this task? (Choose two.)
You work in a data center where VMs and hosts are frequently moved. Your design needs to eliminate inefficient traffic flows. In this scenario, which two solutions will satisfy this requirement? (Choose two.)
Which two statements are correct about VXLANs? (Choose two.)

Question 85 - JN0-682 discussion

Report
Export

After configuring an IP fabric using EBGP as you protocol, you notice that not all of the routers are showing up in the routing tables. You have verified that all adjacencies have formed, and place and configured properly.

In this scenario, which statement is true?

A.
The routers have not been configured with the multipath multiple-as parameter.
Answers
A.
The routers have not been configured with the multipath multiple-as parameter.
B.
The routers have not been configured using the bfd-1 Liveness-detection parameter.
Answers
B.
The routers have not been configured using the bfd-1 Liveness-detection parameter.
C.
The routers have not been configured using the multihop parameter.
Answers
C.
The routers have not been configured using the multihop parameter.
D.
The routers have not been configured using the add-path parameter
Answers
D.
The routers have not been configured using the add-path parameter
Suggested answer: A

Explanation:

If not all routers show up in the routing tables despite formed adjacencies in an EBGP setup, it's likely due to the lack of configuration of the 'multipath multiple-as' parameter. This parameter allows the use of multiple paths for BGP routes even when they originate from different ASes.

Juniper Networks - BGP Multipath

Show Answer
asked 18/09/2024
Yedron Rojas Acosta
49 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms