ExamGecko
Search Search Login
Home Home / Juniper / JN0-682
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

You are troubleshooting an L3VPN that is part of an EVPN/MPLS DCI. You notice that the EVPN overlay BGP session toward 10.29.50.4 is unable to establish. Why is the BGP session failing to establish?
Refer to the exhibit. Referring to the exhibit, which two statements are correct? (Choose two.)
Which two statements about a DHCP relay in an EVPN-VXLAN fabric are correct? (Choose two.)
Which two statements are true Virtual Chassis? (Choose two.)
Which two combinations are supported when configuring a Virtual Chassis Fabric? (Choose two.)
Which protocol is used between VCF member devices to create a loop-free topology?
Referring to the exhibit, each node in the IP fabric is peering to its directly attached neighbor using EBGP. Each node is peering using physical interface IP addresses. Leaf 2 and Leaf 3 are advertising the 10.1.1/24 network into EBGP. Spine 2 must be configured so that it can load- share traffic destined to the 10 1.1/24 network over both next-hop A and next-hop B. Which two actions must be performed to accomplish this task? (Choose two.)
You are asked to enable plug-and-play line card switches in an active VCF without making any future Junos configuration charges. You are also required to ensure that all new line card are automatically upgrade to the correct Junos version without any manual intervention. In this scenario, which two actions will accomplish this task? (Choose two.)
You work in a data center where VMs and hosts are frequently moved. Your design needs to eliminate inefficient traffic flows. In this scenario, which two solutions will satisfy this requirement? (Choose two.)
Which two statements are correct about VXLANs? (Choose two.)

Question 100 - JN0-682 discussion

Report
Export

You are configuring an MX Series router to act as a Layer 3 gateway to route traffic between VXLANs in different data centers across a WAN connection. In this scenario, what must you do to enable this communication?

A.
Configure route reflectors.
Answers
A.
Configure route reflectors.
B.
Change the UDP port used by the VXLANs.
Answers
B.
Change the UDP port used by the VXLANs.
C.
Configure the IRB interfaces to connect the VXLANs.
Answers
C.
Configure the IRB interfaces to connect the VXLANs.
D.
Enable PIM on all interfaces.
Answers
D.
Enable PIM on all interfaces.
Suggested answer: C

Explanation:

To enable communication between VXLANs in different data centers across a WAN connection using an MX Series router, Integrated Routing and Bridging (IRB) interfaces must be configured. IRB interfaces provide Layer 3 routing capabilities within a VXLAN overlay network, allowing for inter-VXLAN routing. By configuring IRB interfaces on the MX router, you enable it to act as a Layer 3 gateway, routing traffic between the different VXLANs across the data centers.

Reference: Juniper Networks MX Series Documentation - VXLAN and EVPN Configuration.

Show Answer
asked 18/09/2024
Caridade Martins
44 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms