ExamGecko
Search Search Login
Home Home / LPI / 201-450
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

What is the purpose of an initramfs during the Linux system start?
Which file in /proc contains information on the status of local software RAID devices?
What are the main network services used by the PXE protocol? (Choose TWO correct answers.)
Fill in the blank: What is the device name for the first SCSI tape drive on a system when used without automatic rewinding after each write operation? (Please specify the full path to the device.)
Where would fsck put any unreferenced file or file fragments on a ext4 filesystem?
Which of the following commands restores only those files containing lpi in their name from the archive lpifiles.tar.gz?
A system has one hard disk and one CD writer which are both connected to SATA controllers. Which device represents the CD writer?
A new kernel version needs to be compiled to use a new feature. If the old kernel configuration file is available, which make target creates a configuration file for the new kernel based on the configuration of the old kernel?
In the following output, the load averages represent the system load averages for what time frames? 12:10:05 up 18 days, 19:00, 2 users, load average: 0.47, 24.71, 35.31
Fill in the blank: Which directory contains system-specific systemd unit files? (Specify the full path to the directory.)

Question 137 - 201-450 discussion

Report
Export

What is the purpose of a system mount unit?

A.
It is used by the command systemd-mount and allows users to mount partitions to mount points of their choice
Answers
A.
It is used by the command systemd-mount and allows users to mount partitions to mount points of their choice
B.
It is used only to mount network file systems to local mount points. It cannot be used for local media
Answers
B.
It is used only to mount network file systems to local mount points. It cannot be used for local media
C.
It is created by the command systemd-fstab-generator to integrate entries from /etc/fstab into the system boot process
Answers
C.
It is created by the command systemd-fstab-generator to integrate entries from /etc/fstab into the system boot process
D.
It is used by the command mount when using system to mount and unmount file systems
Answers
D.
It is used by the command mount when using system to mount and unmount file systems
Suggested answer: A
Show Answer
asked 18/09/2024
Misael E
37 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms