ExamGecko
Search Search Login
Home Home / Nutanix / NCP-MCI-6.5
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibit. An administrator is trying to implement the solution that is shown in the exhibit, but has been unsuccessful. Based on the diagram, what is causing the issue?
Which algorithm do snapshots and clones leverage to maximize efficiency and effectiveness?
Which scenario would benefit most from Erasure Coding being enabled on a container?
Refer to Exhibit: An administrator is attempting to create an additional virtual switch on a newly deployed AHV cluster, using the two currently disconnected interfaces. The administrator is unable to select the disconnected interfaces when creating the virtual switch. What is the likely cause of this issue?
A Nutanix cluster is equipped with four nodes. Four VMs on this cluster have been configured with a VM-VM anti-affinity policy and are each being hosted by a different node. What occurs to the cluster and these VMs during an AHV upgrade?
Which two methods are available when migrating a VM from a legacy 3-tier solution using VMware ESXi to AHV? (Choose two.)
An administrator has been alerted to a VM that has high I/O latency and wants to determine if there are any other factors, such as insufficient network or memory resources that correlate, as part of a troubleshooting process. Which type of chart should the administrator create to allow all relevant data to be easily exported to CSV for later analysis?
Which component can be associated with a storage policy?
An administrator is implementing a VDI solution. The workload will be a series of persistent desktops in a dedicated storage container within a four-node cluster Storage optimizations should be set on the dedicated storage container to give optimal performance including during a node failure event Which storage optimizations should the administrator set to meet the requirements?
An administrator is commissioning a Nutanix Enterprise Cloud. Once the user VMs have been deployed and are running, the administrator finds that VMs on the same host are able to communicate, but are unable to communicate between hosts. What must be changed to enable full inter-VM communications?

Question 49 - NCP-MCI-6.5 discussion

Report
Export

An administrator is performing validation testing of a new-deploy cluster. During this test, the administrator disconnect each LAN interface from each of the nodes while pinging the hypervisor and guest VMs.

When the first interface is disconnected, pings continue as expected to the hypervisor, but pings stop responding from the guest. Pings continue when the interface is reconnected. When the second interface is disconnected, pings continue to both the hypervisor and guest VMs.

What could be the cause of this error?

A.
This is normal behavior for a LAN Failover
Answers
A.
This is normal behavior for a LAN Failover
B.
Switch ports are configured with different VLANs
Answers
B.
Switch ports are configured with different VLANs
C.
Portfast is not enabled on the switch ports
Answers
C.
Portfast is not enabled on the switch ports
D.
One of the network interfaces has a bad patch cable.
Answers
D.
One of the network interfaces has a bad patch cable.
Suggested answer: B

Explanation:

switch ports are configured with different VLANscould be the cause of this error.If the switch ports are not configured with the same VLANs as the network interfaces on each node, then there could be a mismatch in network connectivity when one interface is disconnected1. This could affect the guest VMs that are using a different VLAN than the hypervisor.

Show Answer
asked 23/09/2024
Renata Maria DA SILVA
46 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms