ExamGecko
Search Search Login
Home Home / Nutanix / NCP-MCI-6.5
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibit. An administrator is trying to implement the solution that is shown in the exhibit, but has been unsuccessful. Based on the diagram, what is causing the issue?
Which algorithm do snapshots and clones leverage to maximize efficiency and effectiveness?
Which scenario would benefit most from Erasure Coding being enabled on a container?
Refer to Exhibit: An administrator is attempting to create an additional virtual switch on a newly deployed AHV cluster, using the two currently disconnected interfaces. The administrator is unable to select the disconnected interfaces when creating the virtual switch. What is the likely cause of this issue?
A Nutanix cluster is equipped with four nodes. Four VMs on this cluster have been configured with a VM-VM anti-affinity policy and are each being hosted by a different node. What occurs to the cluster and these VMs during an AHV upgrade?
Which two methods are available when migrating a VM from a legacy 3-tier solution using VMware ESXi to AHV? (Choose two.)
An administrator has been alerted to a VM that has high I/O latency and wants to determine if there are any other factors, such as insufficient network or memory resources that correlate, as part of a troubleshooting process. Which type of chart should the administrator create to allow all relevant data to be easily exported to CSV for later analysis?
Which component can be associated with a storage policy?
An administrator is implementing a VDI solution. The workload will be a series of persistent desktops in a dedicated storage container within a four-node cluster Storage optimizations should be set on the dedicated storage container to give optimal performance including during a node failure event Which storage optimizations should the administrator set to meet the requirements?
An administrator is commissioning a Nutanix Enterprise Cloud. Once the user VMs have been deployed and are running, the administrator finds that VMs on the same host are able to communicate, but are unable to communicate between hosts. What must be changed to enable full inter-VM communications?

Question 68 - NCP-MCI-6.5 discussion

Report
Export

A recently configured cluster is leveraging NearSync with a recovery schedule of 15 minutes. It is noticed that the cluster is consistently transitioning in an Out of NearSyne.

What action should be taken to potentially address this issue?

A.
Increase network bandwidth
Answers
A.
Increase network bandwidth
B.
Change the NearSync schedule to 30 minutes.
Answers
B.
Change the NearSync schedule to 30 minutes.
C.
Add a vCPUs to the user VMs.
Answers
C.
Add a vCPUs to the user VMs.
D.
Configure a secondary schedule in the same Protection Domain.
Answers
D.
Configure a secondary schedule in the same Protection Domain.
Suggested answer: A

Explanation:

One of the possible reasons for a cluster to transition out of NearSync is insufficient network bandwidth between the source and target clusters.NearSync requires a minimum network bandwidth of 10 Mbps per VM for replication3. If the network bandwidth is lower than the required amount, the replication of recovery points may take longer than the configured RPO, resulting in an Out of NearSync condition.To address this issue, you can increase the network bandwidth between the clusters or reduce the number of VMs protected by NearSync4.

Show Answer
asked 23/09/2024
Ibrahim Ramku
51 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms