Home / CompTIA / N10-008

Question list

List of questions

Question 1

(0)

A systems administrator needs to improve WiFi performance in a densely populated office tower and use the latest standard. There is a mix of devices that use 2.4 GHz and 5 GHz. Which of the followin

Question 2

(0)

Which of the following would be BEST to use to detect a MAC spoofing attack?

Question 3

(0)

A technician receives feedback that some users are experiencing high amounts of jitter while using the wireless network. While troubleshooting the network, the technician uses the ping command with

Question 4

(0)

Wireless users are reporting intermittent internet connectivity. Connectivity is restored when the users disconnect and reconnect, utilizing the web authentication process each time. The network adm

Question 5

(0)

A network administrator walks into a datacenter and notices an unknown person is following closely. The administrator stops and directs the person to the security desk. Which of the following attack

Question 6

(0)

A network is experiencing a number of CRC errors during normal network communication. At which of the following layers of the OSI model will the administrator MOST likely start to troubleshoot?

Question 7

(0)

A client recently added 100 users who are using VMs. All users have since reported slow or unresponsive desktops. Reports show minimal network congestion, zero packet loss, and acceptable packet del

Question 8

(0)

Client devices cannot enter a network, and the network administrator determines the DHCP scope is exhausted. The administrator wants to avoid creating a new DHCP pool. Which of the following can the

Question 9

(0)

An administrator is writing a script to periodically log the IPv6 and MAC addresses of all the devices on a network segment. Which of the following switch features will MOST likely be used to assist

Question 10

(0)

Which of the following DNS records works as an alias to another record?

Question 192 - N10-008 discussion

Which of the following needs to be tested to achieve a Cat 6a certification for a company's data cawing?

RJ11

LC ports

Patch panel

F-type connector

Suggested answer: C

Explanation:

To achieve a Cat 6a certification for a company's data cabling, the patch panel needs to betested along with the cable and the connectors. A patch panel is a device that provides aconvenient and flexible way to connect and route circuits for data transmission. It has multipleports that can be wired to different devices or networks. A patch panel can also supportdifferent types of cables and connectors, such as RJ45, LC, or F-type.A Cat 6a certification means that the cabling system meets the performance requirements ofthe ANSI/TIA-568.2-D standard for Category 6a, which specifies a bandwidth of up to 500 MHzand a maximum length of 100 meters for twisted-pair copper cables. To achieve thiscertification, the cabling system must pass a series of tests that measure parameters such asinsertion loss, near-end crosstalk (NEXT), return loss, alien crosstalk (AXT), and propagationdelay. These tests can be performed using a cable tester or a network analyzer.The patch panel is an important component of the cabling system because it affects the signalquality and the reliability of the connections. If the patch panel is not properly wired,terminated, or labeled, it can cause errors, interference, or failures in the data transmission.Therefore, the patch panel must be tested along with the cable and the connectors to ensurethat the cabling system meets the Cat 6a certification standards.The other options are not relevant for the Cat 6a certification. RJ11 is a type of connector thatis used for telephone lines, not data cabling. LC ports are used for fiber optic cables, not coppercables. F-type connectors are used for coaxial cables, not twisted-pair cables.https://community.fs.com/article/what-is-a-patch-panel-and-why-use-it.html

Show Answer

asked 02/10/2024

Michel van Klaveren

38 questions

Your answer: A B C D

0 comments

Sorted by