SIMULATION
A network technician replaced a switch and needs to reconfigure it to allow the connected devices to connect to the correct networks.
INSTRUCTIONS
Click on the appropriate port(s) on Switch 1 and Switch 3 to verify or reconfigure the correct settings:
•bullet Ensure each device accesses only its correctly associated network
•bullet Disable all unused switch ports
•bullet Require fault-tolerant connections between the switches
•bullet Only make necessary changes to complete the above requirements
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.

Question

SIMULATIONA network technician replaced a switch and needs to reconfigure it to allow the connected devices to connect to the correct networks.INSTRUCTIONSClick on the appropriate port(s) on Switch 1 and Switch 3 to verify or reconfigure the correct settings:•bullet  Ensure each device accesses only its correctly associated network•bullet  Disable all unused switch ports•bullet  Require fault-tolerant connections between the switches•bullet  Only make necessary changes to complete the above requirementsIf at any time you would like to bring back the initial state of the simulation, please click the Reset All button.

Ali Reza Farahnak · Accepted Answer

See the explanation for this solution

Ali Reza Farahnak · Answer

Ali Reza Farahnak · Answer

Ali Reza Farahnak · Answer

Question list

List of questions

Question 1

(0)

Question 2

(0)

Question 3

(0)

Question 4

(0)

Question 5

(0)

Question 6

(0)

Question 7

(0)

Question 8

(0)

Question 9

(0)

Question 10

(0)

Related questions

Question 495 - N10-008 discussion

Suggested answer: A

0 comments