ExamGecko
Search Search Login
Home Home / Cisco / 300-815
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Refer to the exhibit. An administrator is troubleshooting a problem in which some outbound calls from an internal network to the Internet telephony service provider are not getting connected, but some others connect successfully. The firewall team found that some call attempts on port 5060 came from an unrecognized IP that has not been defined in the firewall rule. What should the administrator configure in the Cisco Unified Border Element to fix this issue?
Which two extended capabilities must be configured on dial peers for fast start-to-early media scenarios (H.323 to SIP interworking)? (Choose two.)
Refer to the exhibit. A collaboration engineer is troubleshooting an issue where the PSTN calls of a Cisco UCM IP phone user are not reaching the PSTN gateway. Which action resolves the issue?
The same digits sent in OOB, as well as in-band on the Cisco Unified Border Element, are being interpreted as duplicate digits by the receiving end. Which configuration must an engineer implement to resolve this issue?
Which section under the Real-Time Monitoring Tool allows for reviewing the call flow and signaling for a SIP call in real time?
Due to a shortage of physical interfaces on a device the administrator requires that a loopback for RTP is used. Which command is required when using a loopback interface for RTP?
An administrator configured Cisco Unified Mobility to block access to remote destinations for certain caller IDs. A user reports that a blocked caller was able to reach a remote destination. Which action resolves the issue?
An administrator is configuring a cluster for ILS and wants to limit the amount of entities that Cisco Unified Communications Manager can write to the database for data that is learned through ILS. Which service parameter is used to adjust this limit?
Cisco UCM has 100,000 entries in the database learned through the ILS Service. Parameter ILS Max Number of Learned Objects in Database value is set to 100,000. What will happen to learned data when the service parameter value is reduced to 50,000?
What are two configureation features of the Client matter code setting in the route pattern configuration? (Choose two.)

Question 24 - 300-815 discussion

Report
Export

Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?

A.

Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.

Answers
A.

Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.

B.

Configure IP Address Trusted Authentication for Incoming VoIP Calls.

Answers
B.

Configure IP Address Trusted Authentication for Incoming VoIP Calls.

C.

Configure the command no ip address trusted authenticate under ''voice service voip''.

Answers
C.

Configure the command no ip address trusted authenticate under ''voice service voip''.

D.

Enable Secondary Dial tone on Analog and Digital FXO Ports.

Answers
D.

Enable Secondary Dial tone on Analog and Digital FXO Ports.

Suggested answer: B
Show Answer
asked 10/10/2024
Bob Target
38 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms