Home

Home / Cisco / 350-801

Question list

List of questions

Question 1

(0)

An administrator is trying to change the default LINECODE for a voice ISDN T1 PRI. Which command makes the change?

Question 2

(0)

How does an administrator make Cisco IP phone display the last 10 digits of the calling number when the call is in the connected state, and also display the calling number in the E.164 format within

Question 3

(0)

Which configuration tells a switch port to send Cisco Discovery protocol packets that configure an attached Cisco IP phone to trust tagged traffic that is received from a device that is connected to

Question 4

(0)

An engineer configures Cisco Unified Communications Manager to prevent toll fraud. At which two point does the engineer block the pattern in Cisco Unified CM to complete this task? (Choose two.)

Question 5

(0)

What is a software-based media resource that is provided by the Cisco IP Voice Streaming Application?

Question 6

(0)

Multiple route patterns match a number. How does Cisco Unified Communications Manager determine which pattern to use?

Question 7

(0)

A user forwards a corporate number to an international number. What are two methods to prevent this forwarded call? (Choose two.)

Question 8

(0)

An administrator recently upgraded a Cisco Webex DX80 through its web interface but discovered the next morning that the unit had reverted to its previous version. What must the administrator do to

Question 9

(0)

When a phone is registered over Mobile and Remote Access, where does it register?

Question 10

(0)

A network administrator deleted a user from the LDAP directory of a company. The end user shows as Inactive LDAP Synchronize User in Cisco Unified Communications Manager. Which step is next to remov

Open VPLUS File

Convert VPLUS to PDF

Related questions

Where is urgent priority enabled to bypass the T302 timer?

An administrator must implement toll fraud prevention on Cisco UCM using these parameters: • Enable Forced Authorization Code 112211. • Set an authorization level of 3 for the route pattern 8005551212. • Require no access code to dial 10-digit numbers. How must the route pattern be implemented?

An engineer troubleshoots outbound can failure on an ISDN-PRI circuit. The engineer ts suspecting the 'Incomplete Destination". Which debugs or commands are run in the voice gateway to troubleshoot the issue?

An administrator must configure the Local Route Group feature on Cisco UCM. Which step will enable this feature?

Which two parameters influence the total number of supported conference participants on a Cisco IOS XE router that has DSP modules? (Choose two.)

What are two Cisco UCM location bandwidths that are deducted when G 729 and G.711 codecs are used? (Choose two.)

An administrator must make a pattern to route calls to two different destinations john doe@company com and jane doe@company com Which type of patterns are needed in the Cisco UCM. and what must the pattern look like?

An engineer must configure a route pattern that can route all + E.164 globalized international numbers for the dial plans of all countries. Which cisco UCM configuration accomplishes this task?

Why would we not include an end user's PC device in a QoS trust boundary?

Refer to the exhibit. A call is falling to establish between two SIP Devices The called device answers with these SOP Which SOP parameter causes issue?

Question 236 - 350-801 discussion

Report

An engineer must configure a route pattern that can route all +E.164 globalized international numbers for the plans of all countries. Which Cisco UCM configuration accomplish this task?

A.

B.

C.

D.

Show Answer

asked 10/10/2024

Dylan Ogle

45 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first