ExamGecko
Search Search Login
Home Home / Cisco / 350-801
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Where is urgent priority enabled to bypass the T302 timer?
An administrator must implement toll fraud prevention on Cisco UCM using these parameters: • Enable Forced Authorization Code 112211. • Set an authorization level of 3 for the route pattern 8005551212. • Require no access code to dial 10-digit numbers. How must the route pattern be implemented?
An engineer troubleshoots outbound can failure on an ISDN-PRI circuit. The engineer ts suspecting the 'Incomplete Destination". Which debugs or commands are run in the voice gateway to troubleshoot the issue?
Which two parameters influence the total number of supported conference participants on a Cisco IOS XE router that has DSP modules? (Choose two.)
An administrator must configure the Local Route Group feature on Cisco UCM. Which step will enable this feature?
An administrator must make a pattern to route calls to two different destinations john doe@company com and jane doe@company com Which type of patterns are needed in the Cisco UCM. and what must the pattern look like?
After an engineer implements the FAC and CMC features together, users report that calls take almost one minute to complete and that they occasionally hear the reorder tone. Which two actions address this issue?( Choose two)
What are two Cisco UCM location bandwidths that are deducted when G 729 and G.711 codecs are used? (Choose two.)
Which call flow matches traffic from a Mobile and Remote Access registered endpoint to central call control?
An administrator is configuring a new Cisco UCM with PSTN capabilities. Due to bandwidth constraints, audio compression is used on the codec. DTMF must work as expected because the customer is calling many call centers where the users must select options in the call. Where is DTMF out-of-band in a CCM 12.5 with SIP-based gateway configured?

Question 265 - 350-801 discussion

Report
Export

A collaboration engineer troubleshoots issues with a Cisco IP Phone 7800 Series The IPv4 address of the phone is reachable via ICMP and HTTP and the phone is registered to Cisco UCM However, the engineer cannot reach the CLI of the phone Which two actions in Cisco UCM resolve the issue?

(Choose two)

A.

Enable FIPS Mode under Product Specific Configuration Layout in Cisco UCM

Answers
A.

Enable FIPS Mode under Product Specific Configuration Layout in Cisco UCM

B.

Enable Settings Access under Product Specific Configuration Layout in Cisco UCM.

Answers
B.

Enable Settings Access under Product Specific Configuration Layout in Cisco UCM.

C.

Enable SSH Access under Product Specific Configuration Layout in Cisco UCM

Answers
C.

Enable SSH Access under Product Specific Configuration Layout in Cisco UCM

D.

Disable Web Access under Product Specific Configuration Layout in Cisco UCM

Answers
D.

Disable Web Access under Product Specific Configuration Layout in Cisco UCM

E.

Set a username and password under Secure Shell Information in Cisco UCM

Answers
E.

Set a username and password under Secure Shell Information in Cisco UCM

Suggested answer: C, D
Show Answer
asked 10/10/2024
Wilson Geneblazo
33 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms