ExamGecko
Search Search Login
Home Home / Cisco / 350-801
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Where is urgent priority enabled to bypass the T302 timer?
An administrator must implement toll fraud prevention on Cisco UCM using these parameters: • Enable Forced Authorization Code 112211. • Set an authorization level of 3 for the route pattern 8005551212. • Require no access code to dial 10-digit numbers. How must the route pattern be implemented?
An engineer troubleshoots outbound can failure on an ISDN-PRI circuit. The engineer ts suspecting the 'Incomplete Destination". Which debugs or commands are run in the voice gateway to troubleshoot the issue?
An administrator must configure the Local Route Group feature on Cisco UCM. Which step will enable this feature?
Which two parameters influence the total number of supported conference participants on a Cisco IOS XE router that has DSP modules? (Choose two.)
What are two Cisco UCM location bandwidths that are deducted when G 729 and G.711 codecs are used? (Choose two.)
An administrator must make a pattern to route calls to two different destinations john doe@company com and jane doe@company com Which type of patterns are needed in the Cisco UCM. and what must the pattern look like?
An engineer must configure a route pattern that can route all + E.164 globalized international numbers for the dial plans of all countries. Which cisco UCM configuration accomplishes this task?
Why would we not include an end user's PC device in a QoS trust boundary?
Refer to the exhibit. A call is falling to establish between two SIP Devices The called device answers with these SOP Which SOP parameter causes issue?

Question 399 - 350-801 discussion

Report
Export

After an engineer implements the FAC and CMC features together, users report that calls take almost one minute to complete and that they occasionally hear the reorder tone. Which two actions address this issue?( Choose two)

A.

Adjust the T302 timer from the default of 15 seconds to 5 seconds to shorten the interdigit timer

Answers
A.

Adjust the T302 timer from the default of 15 seconds to 5 seconds to shorten the interdigit timer

B.

Change the code if the problem persists

Answers
B.

Change the code if the problem persists

C.

Advise the user to hang up and try again

Answers
C.

Advise the user to hang up and try again

D.

Do not wait for the tones immediately dial the FAC and CMC

Answers
D.

Do not wait for the tones immediately dial the FAC and CMC

E.

Advise the user to press the"#"button after dialing the FAC and CMC codes

Answers
E.

Advise the user to press the"#"button after dialing the FAC and CMC codes

Suggested answer: A, B
Show Answer
asked 10/10/2024
giancarlo bagnetti srl
42 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms