ExamGecko
Search Search Login
Home Home / Cisco / 350-801
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Where is urgent priority enabled to bypass the T302 timer?
An administrator must implement toll fraud prevention on Cisco UCM using these parameters: • Enable Forced Authorization Code 112211. • Set an authorization level of 3 for the route pattern 8005551212. • Require no access code to dial 10-digit numbers. How must the route pattern be implemented?
An engineer troubleshoots outbound can failure on an ISDN-PRI circuit. The engineer ts suspecting the 'Incomplete Destination". Which debugs or commands are run in the voice gateway to troubleshoot the issue?
An administrator must configure the Local Route Group feature on Cisco UCM. Which step will enable this feature?
Which two parameters influence the total number of supported conference participants on a Cisco IOS XE router that has DSP modules? (Choose two.)
What are two Cisco UCM location bandwidths that are deducted when G 729 and G.711 codecs are used? (Choose two.)
An administrator must make a pattern to route calls to two different destinations john doe@company com and jane doe@company com Which type of patterns are needed in the Cisco UCM. and what must the pattern look like?
An engineer must configure a route pattern that can route all + E.164 globalized international numbers for the dial plans of all countries. Which cisco UCM configuration accomplishes this task?
Why would we not include an end user's PC device in a QoS trust boundary?
Refer to the exhibit. A call is falling to establish between two SIP Devices The called device answers with these SOP Which SOP parameter causes issue?

Question 390 - 350-801 discussion

Report
Export

Exhibit.

Refer the exhibit. A collaboration engineer needs to replace the original, single NTP

server that was configured during the inital install of a Cisco UCM server. What is the first

step to accomplish this task?

A.

Restart the NTP service on Cisco UCM

Answers
A.

Restart the NTP service on Cisco UCM

B.

Delete the original NTP server from Cisco UCM

Answers
B.

Delete the original NTP server from Cisco UCM

C.

Stop the NTP service on Cisco UCM

Answers
C.

Stop the NTP service on Cisco UCM

D.

Enable NTP authentication for the new NTP server on Cisco UCM

Answers
D.

Enable NTP authentication for the new NTP server on Cisco UCM

Suggested answer: B
Show Answer
asked 10/10/2024
Vasil Ishmatov
41 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms