ExamGecko
Search Search Login
Home Home / Cisco / 350-801
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

Where is urgent priority enabled to bypass the T302 timer?
An administrator must implement toll fraud prevention on Cisco UCM using these parameters: • Enable Forced Authorization Code 112211. • Set an authorization level of 3 for the route pattern 8005551212. • Require no access code to dial 10-digit numbers. How must the route pattern be implemented?
An engineer troubleshoots outbound can failure on an ISDN-PRI circuit. The engineer ts suspecting the 'Incomplete Destination". Which debugs or commands are run in the voice gateway to troubleshoot the issue?
An administrator must configure the Local Route Group feature on Cisco UCM. Which step will enable this feature?
Which two parameters influence the total number of supported conference participants on a Cisco IOS XE router that has DSP modules? (Choose two.)
An administrator must make a pattern to route calls to two different destinations john doe@company com and jane doe@company com Which type of patterns are needed in the Cisco UCM. and what must the pattern look like?
What are two Cisco UCM location bandwidths that are deducted when G 729 and G.711 codecs are used? (Choose two.)
An engineer must configure a route pattern that can route all + E.164 globalized international numbers for the dial plans of all countries. Which cisco UCM configuration accomplishes this task?
Why would we not include an end user's PC device in a QoS trust boundary?
Refer to the exhibit. A call is falling to establish between two SIP Devices The called device answers with these SOP Which SOP parameter causes issue?

Question 432 - 350-801 discussion

Report
Export

An engineer must configure codec on a Cisco Unified Border Element to prefer the G.711 ulaw and use G.711 codec as the

next The engineer logs In to the CUBE, enters the dial.peer configuration level, and runs the voiceclass codec 100 command. Which set of commands completes the configuration?

A.

voice class codec 100 codec g7llalaw preference 1 codec a7Hulaw preference 2

Answers
A.

voice class codec 100 codec g7llalaw preference 1 codec a7Hulaw preference 2

B.

voice class codec 11j codec <?7iiulaw preferred codec g7iialaw

Answers
B.

voice class codec 11j codec <?7iiulaw preferred codec g7iialaw

C.

vice class codec 100

codec preference 1 g7llulaw

codec preference 2 o711alaw

Answers
C.

vice class codec 100

codec preference 1 g7llulaw

codec preference 2 o711alaw

D.

voice class codec ::: codec g711ulaw g711alaw

Answers
D.

voice class codec ::: codec g711ulaw g711alaw

Suggested answer: C

Explanation:

The following commands are used to configure the codec on a Cisco Unified Border Element to prefer the G.711 ulaw and use G.711 alaw as the next codec:

Code snippet

voice class codec 100

codec preference 1 g711ulaw

codec preference 2 g711alaw

The voice class codec 100 command creates a new voice class with the ID of 100. The codec

preference 1 g711ulaw command sets the preference for the G.711 ulaw codec to 1. The codec preference 2 g711alaw command sets the preference for the G.711 alaw codec to 2.

Show Answer
asked 10/10/2024
Abel Galleguillos
39 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms