ExamGecko
Search Search Login
Home Home / Huawei / H12-811_V1.0
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

If host A has the ARP cache of host B. , host A. can ping host B. ()
SNMP packets are transmitted by UDP.
Only the WPA2-PSK security policy supports TKIP data encryption.
On the network shown in the following figure, assuming that SWA, SWB, and SWC retain factory defaults, which of the following ports will be selected as a designated port?
Which of the following descriptions about the switch is wrong?
The administrator made the configuration on the router as shown in the figure. At the same time, the administrator wants to assign a shorter lease period to the DHCP address. Which of the following commands should be used? () (Single-choice question) ip pool pooll netyork10.10.10.0ask255.255.255.0 gateway-list 10.10.10.1
In the VRP interface, use the command startup saved-configuration backup.cfg. Configure the startup.cfg file to be used at the next startup ()
The configuration information of a certain port of the switch is shown in the figure. Which of the following statements is wrong? () interface GigabitEthernet0/0/1 port link type trunk port trunk pviD. vlan 200 port trunk allow-pass vlan100#
The switch GE0/0/1 port configuration information is shown in the figure. Which VLAN data frame does the switch not carry when forwarding?()
When the FIT AP goes online, the software version will be downloaded from AC.

Question 821 - H12-811_V1.0 discussion

Report
Export

The following figure shows the display interface Eth-Trunk 1 command output on a switch. Which of the following commands can be used to delete Eth-Trunk 1?

A.

inte GigabitEthernet 0/0/1 undo eth-trunk quit inte GigabitEthernet 0/0/2 undo eth-trunk quit undo interface Eth-Trunk 1

Answers
A.

inte GigabitEthernet 0/0/1 undo eth-trunk quit inte GigabitEthernet 0/0/2 undo eth-trunk quit undo interface Eth-Trunk 1

B.

inte GigabitEthernet 0/0/2 undo eth-trunk quit undo interface Eth-Trunk 1

Answers
B.

inte GigabitEthernet 0/0/2 undo eth-trunk quit undo interface Eth-Trunk 1

C.

undo interface Eth-Trunk 1

Answers
C.

undo interface Eth-Trunk 1

D.

inte GigabitEthernet 0/0/1 undo eth-trunk quit undo interface Eth-Trunk 1

Answers
D.

inte GigabitEthernet 0/0/1 undo eth-trunk quit undo interface Eth-Trunk 1

Suggested answer: C

Explanation:

Comprehensive To remove the Eth-Trunk interface, you can simply use the undo interface Eth-Trunk 1 command. This command deletes the entire Eth-Trunk interface from the switch configuration. The other commands involve additional steps to unbind physical interfaces from the Eth-Trunk, but these steps are unnecessary if you are deleting the Eth-Trunk interface entirely.

Show Answer
asked 24/10/2024
Alvaro Alejandro Zorrilla Tello
29 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms