ExamGecko
Home Home / Huawei / H12-811_V1.0

Huawei H12-811_V1.0 Practice Test - Questions Answers

Question list
Search
Search

List of questions

Search

The MAC address table of existing switches is shown in the figure. Which of the following statements are correct? () (Single-choice question)

<Huawei>display mac address

MAC address table of slot 0:

MAC Address VLAN/PEVLAN CEVLAN Port Type LSP/LSR-ID

VSI/SI MAC-Tunnel

5489 9811 0b49 1 Eth0/0/3 static 0/

Total matching items on slot 0 displayed =1

MAC address table of slot 0:

MAC Address VLAN/ PEVLAN CEVLAN Port Type LSP/LSR-ID

VSI/SI MAC-Tunnel

5489-989d-1d30 1 Eth0/0/1 dynamic 0/-

5489-9885-18a8 1 Eth0/0/2 dynamic 0/-

Total matching items on slot 0 displayed =2

A.
The MAC address 5489-9811-0b49 is manually configured by the administrator
A.
The MAC address 5489-9811-0b49 is manually configured by the administrator
Answers
B.
After the switch restarts, all MAC addresses need to be relearned
B.
After the switch restarts, all MAC addresses need to be relearned
Answers
C.
The MAC address 5489-989d-1d30 is manually configured by the administrator
C.
The MAC address 5489-989d-1d30 is manually configured by the administrator
Answers
D.
The MAC address 5489-9885-18a8 is manually configured by the administrator
D.
The MAC address 5489-9885-18a8 is manually configured by the administrator
Answers
Suggested answer: A

In the broadcast network as shown in the figure, 0SPF runs on four routers. And in the same are a. The same network segment. SPF will automatically elect one DR and multiple BDRs to achieve a better backup effect. ()(True or False)

A.
True
A.
True
Answers
B.
False
B.
False
Answers
Suggested answer: B

As shown in the figure below. Which network device can host A and host B use to achieve communication? () (Single-choice question)

A.
HUB
A.
HUB
Answers
B.
Hub
B.
Hub
Answers
C.
Layer 2 switch
C.
Layer 2 switch
Answers
D.
router
D.
router
Answers
Suggested answer: D

The network shown in the figure below. The router receives a data packet with a destination IP address of 11.0.12.1 from host A. After this data is forwarded by the router, what are the destination MAC and destination IP?)(Single-choice question)


A.
MAC-C. 11.0.12.1
A.
MAC-C. 11.0.12.1
Answers
B.
MAC-B. 11.0.12.1
B.
MAC-B. 11.0.12.1
Answers
C.
MAC-D. 10.0.12.2
C.
MAC-D. 10.0.12.2
Answers
D.
MAC-D. 11.0.12.1
D.
MAC-D. 11.0.12.1
Answers
Suggested answer: B

The network structure and OSPF partition are shown in the figure. Except for RTA in the figure, the routers RTB, RTC and RTD are all ABR routers. ()(True or False)

A.
True
A.
True
Answers
B.
False
B.
False
Answers
Suggested answer: B

In the network shown in the figure below, when the 0$PF neighbor status is stable. What is the neighbor status of Router B and Router C?

A.
Full
A.
Full
Answers
B.
2-way
B.
2-way
Answers
C.
Attempt
C.
Attempt
Answers
D.
Down
D.
Down
Answers
Suggested answer: B

In the network shown in the figure below, switch A and router A are connected by two links, and the two links are aggregated in manual load sharing mode. The aggregated port number is 1, and the aggregated link performs data forwarding It needs to carry VLAN TAG100, and switch A uses trunk link. Which of the following configurations should be used for switch A? ()

A.
interface Eth-Trunk 1Port link-type trunkPort trunk allow-pass vlan 100#Interface GigabitEthernet0/0/1Eth-trunk 1#Interface GigabitEthernet0/0/2Eth-trunk 1#
A.
interface Eth-Trunk 1Port link-type trunkPort trunk allow-pass vlan 100#Interface GigabitEthernet0/0/1Eth-trunk 1#Interface GigabitEthernet0/0/2Eth-trunk 1#
Answers
B.
interface Vlanif 100Ip address10.0.12.1255.255.255.0#
B.
interface Vlanif 100Ip address10.0.12.1255.255.255.0#
Answers
C.
interface Eth-Trunk 1Ip address10.0.12.1255.255.255.0#
C.
interface Eth-Trunk 1Ip address10.0.12.1255.255.255.0#
Answers
D.
interface Eth-Trunk 1Mode lacp-staticPort link-type trunkPort trunk allow-pass vlan 100#Interface GigabitEthernet0/0/1Eth-trunk 1#Interface GigabitEthernet0/0/2Eth-trunk 1#
D.
interface Eth-Trunk 1Mode lacp-staticPort link-type trunkPort trunk allow-pass vlan 100#Interface GigabitEthernet0/0/1Eth-trunk 1#Interface GigabitEthernet0/0/2Eth-trunk 1#
Answers
Suggested answer: D

The output information of the STP port of a certain switch is shown in the figure. Which of the following statements is wrong? () (Single-choice question)

[Huawei]display stp interface Ethernet 0/0/1

-------[CIST Global Info][Mode STP]-------

CIST Bridge: 32768.4c1f-cc46-4618

Config TimesHello 4s MaxAge 20s FwDly 15s MaxHop 20

Active Times:Hello 2s MaxAge 20s FwDly 15s MaxHop 20

CIST Root/ERPC:0.4c1f-ccf7-3214/200000

CIST RegRoot/IRPC: 32768.4c1f-cc46-4d18/0

A.
Forward-delay is 20s
A.
Forward-delay is 20s
Answers
B.
Configure the MaxAge of the BPDU to 20s
B.
Configure the MaxAge of the BPDU to 20s
Answers
C.
The period for sending configuration BPDUs on this port is 2s
C.
The period for sending configuration BPDUs on this port is 2s
Answers
D.
The switch is not a root bridge
D.
The switch is not a root bridge
Answers
Suggested answer: A

Telnet is a module that implements the Telnet protocol that comes with Python ()

A.
True
A.
True
Answers
B.
False
B.
False
Answers
Suggested answer: A

Using the command mkdirtest in the VRP operating platform, the system will create a directory named test. ()

A.
True
A.
True
Answers
B.
False
B.
False
Answers
Suggested answer: A
Total 869 questions
Go to page: of 87