Huawei H12-811_V1.0 Practice Test - Questions Answers, Page 87

Detailed

MAC addresses that start with the first octet having the least significant bit (LSB) of the first byte set to 1 (such as 01-02-03-04-05-06) are multicast MAC addresses, and these cannot be assigned to a host's network interface card (NIC). Only unicast MAC addresses can be assigned to hosts.

Detailed

In RSTP, there are three port states: Discarding, Learning, and Forwarding. These states replace the five traditional STP states by combining them to optimize network convergence.

Detailed

An edge port in RSTP (Rapid Spanning Tree Protocol) is designed to immediately transition to the forwarding state without participating in the spanning tree calculation. This allows for quicker convergence and is suitable for ports connected to end devices (not to other switches).

Detailed

Based on the provided configuration, the interfaces on LSW1 and LSW2 are both configured as trunk ports that allow VLAN 10 to pass. This ensures that data frames tagged with VLAN 10 can be transmitted and received across the trunk link between LSW1 and LSW2 without issues.

Detailed

The Priority Code Point (PCP) field in an 802.1Q VLAN tag is 3 bits long, which gives it a value range of 0 to 7. This field is used to indicate the priority of the frame, with higher values indicating higher priority.

Detailed

The Type/Length field value of 0x0800 indicates that the upper-layer protocol is IPv4. However, the length of the IPv4 header can range from 20 to 60 bytes, not the length of the entire upper-layer packet. The field refers to the type of the encapsulated protocol, and the length is not constrained to the header alone.

Detailed

In NAPT, port numbers are dynamically assigned as traffic flows through the router. The port number range is automatically selected, and manual configuration of each mapping is not required. NAPT dynamically uses different ports for mapping private IP addresses to a single public IP address.

Detailed

Huawei AR G3 series routers support various AAA authentication modes including RADIUS, local authentication, no authentication (None), and 802.1X. These modes offer flexibility in how users are authenticated for network access depending on the security requirements.