The ACL configuration information of a certain router is shown in the figure. Which of the following statements is correct? () (Single-choice question)

The packet with the source IP address of 192.168.1.1 is matched by the pemit rule

The packet whose source IP address is 192.168.1.254 is matched by the permit rule

Packets with source IP addresses of 192.168.1.1 and 192.168.1.254 are matched by the permit rule

The packet with the source IP address of 192.168.1.1 is matched by the pemit rule

The packet with the source IP address 192.168.1.1 is matched by the deny rule

As shown in the figure below, in the MAC address table of the network. SWA and SWB, which of the MAC addresses, VLANs, and ports are correct? () (Single-choice question)

SWB:MAC Address VLANPortMAC-AMAC-BMAC-C10GEC/0/3GEC/0/3GEC/0/120100

SWB:MAC Address VLANPortMAC-AMAC-BMAC-C100200100GEC/0/3GEC/0/3GEC/0/1

SWA:MAC AddressVLANPortMAC-AMAC-BMAC-C10GEC/O/1GEC/0/2GEC/0/320100

SWB:MAC Address VLANPortMAC-AMAC-BMAC-C10GEC/0/3GEC/0/3GEC/0/120100

SWA:MACAddress VLANPortMAC-AMAC-BMAC-C10GEC/0/320GEC/0/3GEC/0/3100

As shown in the picture. About OSPF topology and configuration. Which of the following statements is correct? () (Single-choice question)

As long as the interface network type of R1 is restored to the default broadcast type, and the hello time is adjusted to 10s, R1 and R2 can establish a stable neighbor relationship

R1 and R2 can establish a stable OSPF neighbor relationship

R1 is more likely to become DR than R2, because its interface DR priority value is smaller

As long as the interface network type of R1 is restored to the default broadcast type, R1 and R2 can establish a stable neighbor relationship

As long as the interface network type of R1 is restored to the default broadcast type, and the hello time is adjusted to 10s, R1 and R2 can establish a stable neighbor relationship

As shown in the figure below. All hosts can communicate normally. Is the corresponding relationship between SWA MAC address and port correct? () (Single-choice question)

MAC-A GO/0/1MAC-B GO/0/2MAC-C GO/0/3

MAC-A GO/0/1MAC-B G0/0/2MAC-C G0/0/1

MAC-A G0/0/2MAC-B GO/0/2MAC-C GO/0/3

MAC-A GO/0/1MAC-B GO/0/1MAC-C GO/0/3

MAC-A GO/0/1MAC-B GO/0/2MAC-C GO/0/3

The configuration information of a certain port of the switch is shown in the figure. Which of the following statements is wrong? () (Single-choice question)

If the VLAN TAG carried in the data frame is 100, the switch will strip off the VLAN TAG and send it out

If the VLAN TAG carried in the data frame is 200, the switch will strip off the VLAN TAG and send it out

If the port receives a data frame without VLAN TAG, the switch needs to add VLAN TAG100

If the VLAN TAG carried in the data frame is 100, the switch will strip off the VLAN TAG and send it out

The MAC address table of a certain switch is shown in the figure. If the switch receives a data frame with a destination MAC of 5489-9811-0b49 from port Eth0/0/2, which of the following statements is correct? ()

Forward this data frame from the Eth0/0/3 port

Forward this data frame from the Eth0/0/2 port

Forward this data frame from the Eth0/0/3 port

The network shown in the figure below. The network where host A is required to access the Internet through Easy IP, then which of the following ACLs should be used on the G0/0/3 interface of router A? () (Single-choice question)

acl number 2000 Rule 5 permit source 10.0.13.0.0.0.0.255#

acl number 2000 Rule 5 permit source 10.0.12.0.0.0.0.255#

acl number 2000 Rule 5 permit source 10.0.13.0.0.0.0.255#

acl number 2000 Rule 5 permit source 10.0.12.1.0.0.0.0#

acl number 2000 Rule 5 permit source 10.0.13.1.0.0.0.0

As shown in the figure, the administrator hopes that all hosts cannot access the Internet from 8:00 to 17:00 every day. Which ACL rule needs to be bound to traffic-filter outbound in the interface configuration of G0/0/1? () (Single-choice question)

time-range am9 to pm5 08:00 to 17:00 daily # Acl number 2001 Rule 5 deny time-range am9 to pm5 #

time-range am9 to pm5 08:00 to 17:00 working-day # Ac1 number 2003 Rule 5 deny time-range am9 to pm560 H12-811HCIA-Datacom655 new question bank#

time-range am9 to pm5 08:00 to 17:00 daily # Acl number 2001 Rule 5 deny time-range am9 to pm5 #

time-range am9 to pm5 07:00 to 18:00 daily # Acl number 2002 Rule 5 permit time-range am9 to pm5 #

time-range am9 to pm5 08:00 to 17:00 off-day # Acl number 2004 Rule 5 permit time-range am9 to pm5

Regarding the configuration shown in the figure, which statement is correct? () (Single-choice question)

history-command max-size20 is to adjust the size of the history named cache to 20

The default size of the history command cache is 5 bytes

After the above configuration is completed, the history command buffer can store 20 bytes of commands

The default size of the history command cache is 5

The network shown in the figure below. The administrator wants RTA to use a static router. Priority is given to sending data packets to RTB's LoopbackO interface through G0/0/1 port. At the same time, G0/0/2 is used as a backup. Then any configuration on RTA can be Realize this requirement? () (Single-choice question)

ip route-static10.0.2.2255.255.255.25510.0.12.2Ip route-static10.0.2.2255.255.255.25510.0.21.2 preference 70

ip route-static10.0.2.2255.255.255.25510.0.12.2Ip route-static10.0.2.2255.255.255.25510.0.21.2 preference 40

ip route-static10.0.2.2255.255.255.25510.0.12.2Ip route-static10.0.2.2255.255.255.25510.0.21.2

ip route-static10.0.2.2255.255.255.25510.0.12.2 preference 70Ip route.-static10.0.2.2255.255.255.25510.0.21.2

ip route-static10.0.2.2255.255.255.25510.0.12.2Ip route-static10.0.2.2255.255.255.25510.0.21.2 preference 70

In the network shown in the figure below, the switch uses VLANIF interfaces to connect with the router sub-interfaces. Which of the following configurations can achieve this requirement? () (Singlechoice question)

interface Vlanif10Ip address10.0.12.1255.255.255.0#Interface GigabitEthernet 0/0/2Port link-type trunkPort trunk allow-pass vlan 10#

interface Vlanif10Ip address10.0.12.1255.255.255.0#Interface GigabitEthernet 0/0/2Port link-type trunkPort trunk pvid 10Port trunk allow-pass vlan 10#

interface Vlanif10Ip address10.0.12.1255.255.255.0#Interface GigabitEthernet 0/0/2Port link-type trunkPort trunk allow-pass vlan 10#

interface Vlanif10Ip address10.0.12.1255.255.255.0#Interface GigabitEthernet 0/0/267Port link-type hybridPort hybrid untag vlan 10#

interface Vlanif10Ip address10.0.12.1255.255.255.0#Interface GigabitEthernet 0/0/2Port link-type accessPort default vlan 10

As shown in the figure, is the description of this network topology correct? () (Single-choice question)

There are 2 broadcast domains in this network

There are 6 broadcast domains in this network

There are 12 conflict domains in this network

There are 6 conflict domains in this network

There are 2 broadcast domains in this network

The configuration information of a certain router is shown in the figure. Which of the following statements are correct? () (Single-choice question)#aaaauthentication-scheme defaultauthentication-scheme huaweiauthentication-mode radiusauthorization-scheme defaultauthorization-scheme huaweiaccounting-scheme defaultdomain defaultdomain default admindomain huaweiauthentication-scheme huaweiauthorization-scheme huaweilocal-user huawei password cipher 123456local-user huawei@huawei password cipher 654321#

The authorization method for the domain with the domain name huawei is local authorization

The domain with the domain name huawei does not use the billing plan

Use the username huawei for authentication. The password needs to be 654321

The authentication method adopted for the domain with the domain name huawei is local authentication

The authorization method for the domain with the domain name huawei is local authorization

The output information of the router is shown in the figure. Which of the following statements is wrong? () (Single-choice question)

The MTU value of the Ethernet0/0/0 interface is 1480

The broadcast address corresponding to the Ethernet0/0/0 interface is 10.0.12.255

The physical link of the Ethernet0/0/0 interface is normal

Ethernet (The IP address of the /0/0 interface is 10.0.12.1/24

The MAC address table of existing switches is shown in the figure. Which of the following statements are correct? () (Single-choice question)

The data frame with the source MAC address of 5489-9885-18a8 and the destination MAC address of 5489-989d-1d30 is received from the port. It is forwarded from the Eth0/0/1 port

Received a data frame with a source MAC address of 5489-9811-0b49 and a destination MAC address of 5489-989d1d30 from the port. Forwarded from the Eth0/0/2 port

The data frame with the source MAC address of 5489-9885-18a8 and the destination MAC address of 5489-989d-1d30 is received from the port. It is forwarded from the Eth0/0/1 port

When the switch restarts, the MAC address learned by port Eth0/0/2 does not need to be relearned

The MAC address table of existing switches is shown in the figure. Which of the following statements are correct? () (Single-choice question)

The MAC address 5489-9811-0b49 is manually configured by the administrator

The MAC address 5489-989d-1d30 is manually configured by the administrator

After the switch restarts, all MAC addresses need to be relearned. The MAC address 5489-9885-18a8 is manually configured by the administrator

The MAC address 5489-9885-18a8 is manually configured by the administrator

Network as shown in the picture. The administrator hopes that all hosts cannot access the Web service (the port number is 80). Other services can be accessed normally. In the interface configuration of G0/0/1, which ACL rule needs to be bound to trattie-frilter outbound?

acl number 3000Rule 5 deny tcp destination-port eq www Rule 10 permit ip#

rule 5 permit ipARule 10 deny top destination-port eq ww#

acl number 3003Rule 5 permit ipRule 10 deny udp destination-port eq ww#

acl number 3001Rule 5 deny udp destination-port eq wwRule 10 permit ip#

acl number 3000Rule 5 deny tcp destination-port eq www Rule 10 permit ip#

When a company's network management needs to plan the network, the data packets that allow PC1 to access PC2 go through the G0/0/0 port (G0/0/2 on the picture). The data packet that PC2 accesses to PC1 goes from port G0/0/4 (G0/0/0 in the picture). () (Single-choice question)

10.0.12.5255.255.255.25511.0.12.210.0.12.1255.255.255.25511.0.12.5

10.0.12.5255.255.255.25511.0.12.6#10.0.12.1255.255.255.25511.0.12.1

10.0.12.5255.255.255.25511.0.12.210.0.12.1255.255.255.25511.0.12.5

0.0.0.00.0.0.00#11.0.12.6#11.0.12.10

0.0.0#0.0.0.00#11.0.12.2#11.0.12.50

Two switches use manual link aggregation at the same time. The following statement is wrong. () (Single-choice question)

Turn off the G0/0/1 and G0/0/2 ports on switch B, and the Efh-Trunk status is still UP

Only switch off G0/0/2 port on switch B. The Eth-Trunk status is still UP

Turn off the G0/0/1 and G0/0/2 ports on switch B, and the Efh-Trunk status is still UP

Only switch off G0/0/1 port on switch B. The Eth-Trunk status is still UP

Turn off the G0/0/1 and G0/0/2 ports on switch B. The Eth-Trunk status is down

Huawei H12-811_V1.0 Practice Test 2 - Free Online Exam Questions 41-80

As shown in the figure, a static NAT command is deployed on router R1. When the PC accesses the Internet, the destination address in the data packet will not change. ()(True or False)

Huawei H12-811_V1.0 image Question 41 33616 09182024192851000000

True

False

Comment (0)

Huawei H12-811_V1.0 Practice Test 2

Question

Drag and Drop

Hot Area

Huawei H12-811_V1.0 Practice Tests

Practice Tests