In the network shown in the figure below, switch A and router A are connected by two links, and the two links are aggregated in manual load sharing mode. The aggregated port number is 1, and the aggregated link performs data forwarding It needs to carry VLAN TAG100, and switch A uses trunk link. Which of the following configurations should be used for switch A? ()

interface Eth-Trunk 1Mode lacp-staticPort link-type trunkPort trunk allow-pass vlan 100#Interface GigabitEthernet0/0/1Eth-trunk 1#Interface GigabitEthernet0/0/2Eth-trunk 1#

interface Eth-Trunk 1Port link-type trunkPort trunk allow-pass vlan 100#Interface GigabitEthernet0/0/1Eth-trunk 1#Interface GigabitEthernet0/0/2Eth-trunk 1#

interface Vlanif 100Ip address10.0.12.1255.255.255.0#

interface Eth-Trunk 1Ip address10.0.12.1255.255.255.0#

interface Eth-Trunk 1Mode lacp-staticPort link-type trunkPort trunk allow-pass vlan 100#Interface GigabitEthernet0/0/1Eth-trunk 1#Interface GigabitEthernet0/0/2Eth-trunk 1#

The output information of the STP port of a certain switch is shown in the figure. Which of the following statements is wrong? () (Single-choice question)[Huawei]display stp interface Ethernet 0/0/1-------[CIST Global Info][Mode STP]-------CIST Bridge: 32768.4c1f-cc46-4618Config TimesHello 4s MaxAge 20s FwDly 15s MaxHop 20Active Times:Hello 2s MaxAge 20s FwDly 15s MaxHop 20CIST Root/ERPC:0.4c1f-ccf7-3214/200000CIST RegRoot/IRPC: 32768.4c1f-cc46-4d18/0

Configure the MaxAge of the BPDU to 20s

The period for sending configuration BPDUs on this port is 2s

The switch is not a root bridge

The router receives a data packet with a destination IP address of 11.0.12.1 from host

After this data packet is forwarded by the router, what are the destination MAC. and destination IP? ()

Complete the ACL configuration shown in the figure on the router RTA. Which of the following descriptions is correct? () (Single-choice question)(RTA) acl 2001(RTA-acl-basic-2001) rule 20 permit source 20.1.1.0 0.0.0.255[RTA-acl-basic-2001]rule 10 deny source 20.1.1.0 0.0.0.255

The VRP system will first match the rule deny source20.1.1.00.0.0.255 according to the sequence number.

The VRP system will adjust the sequence number of the first rule to 5 according to the configuration sequence.

The VRP system will not adjust the sequence number, but will first match the rule permit source 20.1.1.00.0.0.255

The VRP system will first match the rule deny source20.1.1.00.0.0.255 according to the sequence number.

The sequence number of configuration error rules must be configured from small to large

As shown in the figure, there are three data packets captured by the administrator on the network.Which of the following statements is incorrect? (Single choice question) Source destination protocol info 10.0.12.110.0.12.2TCp50190>telnet[SYN]seq=0win=8192Len=0mss=146010.0.12.2 10.0.12.1 TCP telnet:50190 [SYN,ACK]seg-0 Ack-1 win-8192 Len-0mss=1460 10.0.12.110.0.12.2 TCP50190>telnet(ACK)seq-1Ack=1win=81921en=0

The IP address of the telnet server is 10.0.12.1. The IP address of the telnet client is 10.0.12.2

None of these three data packets contain application layer data

These three data packets represent the three-way handshake process of TCP

The telnet client uses port 50190 to establish a connection with the server

The IP address of the telnet server is 10.0.12.1. The IP address of the telnet client is 10.0.12.2

As shown in the figure, when the switch needs to forward frames with the destination mac address of 5489-98ec-f011, which of the following descriptions is correct? () (Single-choice question)

The switch will be All ports outside flood the frame

The switch will send a message that the destination is unreachable to the source device

The switch did not find a matching entry in the mac address table. So the frame will be discarded

The switch needs to send a request to discover the device with the mac address of 5489-98ec-f011

The switch will be All ports outside flood the frame

The network administrator configures the RTA on the Huawei router as shown in the figure. If a user needs to be authenticated in the authentication domain "huawei", which of the following descriptions is correct? () (Single-choice question)(RTA) aaa(RTA-aaa) domain huawei(RTA-aaa-doaain huavei) authentication -schene au1(RTA-aaa-dogairhuavel) authenticIcation-schene au2

"Authentication-scheme au2 authentication will be used. If "au2" is deleted, "aul authentication will be used

Will use "authentication-scheme aul" authentication

"Authentication-scheme aul authentication will be used. If "au1 is deleted."au2 authentication will be used

"Authentication-scheme au2 authentication will be used. If "au2" is deleted, "aul authentication will be used

Will use "authentication-scheme au2" authentication

What is wrong about the description of the information as shown in the figure? () (Single-choice question)(RI) display interface g0/0/0GlgabltEtherneto/0/0 current state :Adainistratively DOWN Line protocol current state :DOWN

The GigbitEthernet0/0/0 interface was manually closed by the administrator

GigbitEthernet (/0/0 interface is connected to a wrong cable

The GigbitEthernet0/0/0 interface is not configured with an IP address

The GigbitEthernet0/0/0 interface was manually closed by the administrator

GigbitEthernet (0/0/0 interface does not enable dynamic routing protocol

The information shown in the figure is the port status information displayed on a switch running STP. According to this information, what is wrong in the following description? () (Single-choice question)

The priority of this switch is 0

This switch is the root switch in the network

The priority of this switch is 0

This network may only contain this switch

This switch may be connected to 6 other switches

As shown in the figure below, all hosts can communicate normally. Is the correspondence between the MAC address and the port in the MAC address table of SWB correct? () (Single-choice question)

MAC-A GO/0/3MAC-B GO/0/3MAC-C GO/0/1

MAC-A GO/0/1MAC-B GO/0/2MAC-C GO/0/3

MAC-A GO/0/2MAC-B G0/0/2MAC-C GO/0/3

MAC-A GO/0/3MAC-B GO/0/3MAC-C GO/0/1

MAC-A GO/0/1MAC-B GO/0/1MAC-C GO/0/3

The administrator has configured the router as shown in the figure. Then a host connected to the G1/0/0 interface of the router. What kind of IP address can be obtained through DHCP? () (Singlechoice question)

The IP address obtained by the host belongs to the 10.10.10.0/24 network

The IP address obtained by the host belongs to the 10.20.20.0/24 network

The IP address obtained by the host may belong to the 10.10.10.0/24 network, or it may belong to the 10.20.20.0/24 network

As shown in the figure below, which of the following statements is correct? () (Single-choice question)

Only if the masks of host A and host B are set to be the same, host A and host B can communicate

The IP address mask b of host A and host B are different. Therefore, host A and host B cannot communicate

The broadcast address of host A and host B are the same

As shown in the figure, the network administrator creates VLAN2 on SWA and SWB. The ports connecting the hosts on the two switches are configured as Access ports. They are assigned to VLAN2. G0/0/1 of SWA and G0/0/2 of SWB are configured as Trunki ports. All VLANs are allowed to pass. What is needed to achieve normal communication between two hosts? () (Single-choice question)

Create VLAN2 on SWC, configure G0/0/1 and G0/0/2 as trunk ports, and allow VLAN2 to pass

Configure G0/0/1 on SWC as a trunk port and allow VLAN2 to pass. Set G0/0/2 as an access port. PVID is 2.

Create VLAN2 on SWC, configure G0/0/1 and G0/0/2 as trunk ports, and allow VLAN2 to pass

Configure G0/0/1 on SWC as a teunk port and allow VLAN2 to pass through

Huawei H12-811_V1.0 Practice Test 1 - Free Online Exam Prep & Questions

Question 1 / 40

The MAC address table of existing switches is shown in the figure. Which of the following statements are correct? () (Single-choice question)

<Huawei>display mac address

MAC address table of slot 0:

MAC Address VLAN/PEVLAN CEVLAN Port Type LSP/LSR-ID

VSI/SI MAC-Tunnel

5489 9811 0b49 1 Eth0/0/3 static 0/

Total matching items on slot 0 displayed =1

MAC address table of slot 0:

MAC Address VLAN/ PEVLAN CEVLAN Port Type LSP/LSR-ID

VSI/SI MAC-Tunnel

5489-989d-1d30 1 Eth0/0/1 dynamic 0/-

5489-9885-18a8 1 Eth0/0/2 dynamic 0/-

Total matching items on slot 0 displayed =2

The MAC address 5489-9811-0b49 is manually configured by the administrator

After the switch restarts, all MAC addresses need to be relearned

The MAC address 5489-989d-1d30 is manually configured by the administrator

The MAC address 5489-9885-18a8 is manually configured by the administrator

Comment (0)

Huawei H12-811_V1.0 Practice Test 1

Question

Huawei H12-811_V1.0 Practice Tests

Practice Tests