Home

Home / HP / HPE6-A72

Question list

List of questions

Question 1

(0)

Core# configure terminal Core(config)# vrf Green Core(config-vrf)# exit Core(config)# Core(config)# interface vlan 50 Core(config-if-vlan)# ? Given the configuration on the CORE switch shown a

Question 2

(0)

Refer to the exhibit. Using the static IP address configured above, what is the converted binary value of the third octet assigned to the local interface?

Question 3

(0)

What is the correct description of a Multi-Layer Switch?

Question 4

(0)

What is true about VSX? (Choose two.)

Question 5

(0)

Refer to the exhibit. What change on Core-1 will result in a successful ping to 10.1.1.254 from the management interface?

Question 6

(0)

ServiceOS login: admin SVOS> password Enter password: ******** Confirm password: ******** The login password to access an Aruba AOS-CX was lost. After connecting to the switch console port, a

Question 7

(0)

Refer to the exhibit. The Aruba 8400 in the exhibit is member 2 of a VSX stack. Which command will enter the interface sub configuration mode for the port, indicated by the orange square?

Question 8

(0)

What are two features of the three-tier designs? (Choose two.)

Question 9

(0)

Refer to the exhibit. The above scenario shows a packet from the Server destined for the Firewall. Switch-A and Switch-B are bundled as VSF stack. The LAG between the VSF stack and the firewall i

Question 10

(0)

The section in blue can be ignored. SW1(config)# interface 1/1/1-1/1/2 SW1(config-if-<1/1/1-1/1/2)# vlan access 2 SW1(config-if-<1/1/1-1/1/2)# exit SW1(config)# interface 1/1/11-1/1/17 SW

Open VPLUS File

Convert VPLUS to PDF

Related questions

You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch. What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

Refer to the exhibit. The above command was applied to an Aruba AOS-CX 6300M 24-port switch with 4-port SFP56 uplinks. All ports are set as access switchports. Which ports carry VLAN 1 traffic?

What is the process where a compute device converts logical data bits into the correct physical representation depending on the media?

Refer to the exhibit. What change on Core-1 will result in a successful ping to 10.1.1.254 from the management interface?

What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?

What connectivity commands are available on AOS-CX switches? (Choose two.)

Refer to the exhibit. You are in the process of configuring VSF between Access-1 and Access-2. Access-1 has been configured as the VSF Master. What is a valid configuration for Access-2 to join the VSF stack?

Which two port characteristics must match between LAG interfaces? (Choose two.)

Core(config)# user admin password Core(config)# interface mgmt Core(config-if-mgmt)# ip static 10.254.16.89/22 Core(config-if-mgmt)# default-gateway 10.254.19.129 Core(config)# ssh server vrf mgmt Core(config)# https-server vrf mgmt You are tasked with configuring the Core switch to be managed by NetEdit. Currently, the Core switch is at factory-default settings. Which two steps are missing? (Choose two.)

Refer to the exhibit. Traffic is failing between Core-1 and Host-B. IP addressing has correctly been applied, and all interfaces are attached to the vrf GREEN. Which configuration will correct the issue?

Question 36 - HPE6-A72 discussion

Report

Refer to the exhibit.

The above output is the result of issuing the command show system resource-utilization.

What command should be used to enable terminal output line by line or page by page?

A.

The command page

B.

The command terminal length 30

C.

The command more

D.

The command less

Show Answer

asked 16/09/2024

matthew kim

40 questions

User

Your answer: A B C D

0 comments

Sorted by

Leave a comment first