An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.
What would cause this problem?

Question

An administrator is defining a VSX LAG on a pair of AOS-CX switches that are defined as primary and secondary. The VSX LAG fails to establish successfully with a remote switch; however, after verification, the remote switch is configured correctly. The administrator narrows down the problem to the configuration on the AOS-CX switches.

What would cause this problem?

Naveen Kotipalli · Accepted Answer

The VSX LAG hash does not match the remote peer

Naveen Kotipalli · Answer

Local optimization was not enabled on the VSX LAG

Naveen Kotipalli · Answer

The VSX LAG interfaces are in layer-3 mode

Naveen Kotipalli · Answer

LACP was enabled in active mode on the VSX LAG

Question list

List of questions

Question 1

(0)

Question 2

(0)

Question 3

(0)

Question 4

(0)

Question 5

(0)

Question 6

(0)

Question 7

(0)

Question 8

(0)

Question 9

(0)

Question 10

(0)

Related questions

Question 58 - HPE6-A73 discussion

Suggested answer: B

0 comments