ExamGecko
Search Search Login
Home Home / CWNP / CWNA-109
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

When using a spectrum to look for non Wi-Fi interference sources, you notice significant interference across the entire 2.4 GHz band (not on a few select frequencies) within the desktop area of a users workspace, but the interference disappears quickly after just 2 meters. What is the most likely cause of this interference?
ABC Company is planning a point-to-multipoint outdoor bridge deployment with standalone (autonomous) 802.11 bridge units. 802.1X/EAP will be used for bridge authentication. A Linux-based RADIUS server will be used for authentication. What device in the bridge implementation acts as the 802.1X Authenticator?
Which one of the following channels can be used for VHT transmissions according to the 802.11 specification?
What statement describes the authorization component of a AAA implementation?
A WLAN is implemented using wireless controllers. The APs must locate the controllers when powered on and connected to the network. Which one of the following methods is commonly used to locate the controllers by the APs?
An IEEE 802.11 amendment is in the daft state. What impact does this draft amendment have on the 802.11 standard?
You must plan for POE in an office environment. Which one of these devices is least likely to be a POE PSE?
Which one of the following is not a factor considered when calculating the Link Budget for an outdoor point-to- point WLAN bridge link?
You have received a report of poor wireless connections on the third floor of a building under your administration. Three individuals have reported the problem. Apparently, the connections are reporting a strong signal, but the users cannot access the Internet. With the problem identified, what is the next logical step in the troubleshooting process?
A dual-band 802.11ac AP must be powered by PoE. As a class 4 device, what power level should be received at the AP?

Question 38 - CWNA-109 discussion

Report
Export

Option 43 must be configured to allow access points to locate controllers. In what network service should this option be configured?

A.
DNS
Answers
A.
DNS
B.
LDAP
Answers
B.
LDAP
C.
DHCP
Answers
C.
DHCP
D.
RADIUS
Answers
D.
RADIUS
Suggested answer: C

Explanation:

DHCP (Dynamic Host Configuration Protocol) is the network service where option 43 must be configured to allow access points to locate controllers. DHCP is a protocol that allows a device to obtain an IP address and other network configuration parameters from a server. In a wireless controller scenario, the access points can use DHCP to request an IP address from a DHCP server, which can also provide the IP address or hostname of the wireless controller as an option in the DHCP response. Option 43 is a vendor-specific option that can be used to encode custom information for different types of devices. For example, Cisco access points can use option 43 to receive the IP address of the wireless controller from the DHCP server, while Aruba access points can use option 43 to receive the hostname of the wireless controller from the DHCP server.This way, the access points can discover the wireless controller and establish a connection with it.Reference:1, Chapter 8, page 309;2, Section 5.2

Show Answer
asked 16/09/2024
Brian Charlton,
43 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms