ExamGecko
Search Search Login
Home Home / CWNP / CWNA-109
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

When using a spectrum to look for non Wi-Fi interference sources, you notice significant interference across the entire 2.4 GHz band (not on a few select frequencies) within the desktop area of a users workspace, but the interference disappears quickly after just 2 meters. What is the most likely cause of this interference?
ABC Company is planning a point-to-multipoint outdoor bridge deployment with standalone (autonomous) 802.11 bridge units. 802.1X/EAP will be used for bridge authentication. A Linux-based RADIUS server will be used for authentication. What device in the bridge implementation acts as the 802.1X Authenticator?
Which one of the following channels can be used for VHT transmissions according to the 802.11 specification?
What statement describes the authorization component of a AAA implementation?
A WLAN is implemented using wireless controllers. The APs must locate the controllers when powered on and connected to the network. Which one of the following methods is commonly used to locate the controllers by the APs?
An IEEE 802.11 amendment is in the daft state. What impact does this draft amendment have on the 802.11 standard?
You must plan for POE in an office environment. Which one of these devices is least likely to be a POE PSE?
Which one of the following is not a factor considered when calculating the Link Budget for an outdoor point-to- point WLAN bridge link?
You have received a report of poor wireless connections on the third floor of a building under your administration. Three individuals have reported the problem. Apparently, the connections are reporting a strong signal, but the users cannot access the Internet. With the problem identified, what is the next logical step in the troubleshooting process?
A dual-band 802.11ac AP must be powered by PoE. As a class 4 device, what power level should be received at the AP?

Question 60 - CWNA-109 discussion

Report
Export

What 802.11 network configuration would result in multiple stations broadcasting Beacon frames with the same BSSID but with different source addresses?

A.
Multiple APs have been loaded with the same configuration from an image file.
Answers
A.
Multiple APs have been loaded with the same configuration from an image file.
B.
A single AP supports multiple BSSs with different SSIDs.
Answers
B.
A single AP supports multiple BSSs with different SSIDs.
C.
An IBSS is used instead of a BSS.
Answers
C.
An IBSS is used instead of a BSS.
D.
An SCA network is in use.
Answers
D.
An SCA network is in use.
Suggested answer: C

Explanation:

An IBSS is used instead of a BSS is a network configuration that would result in multiple stations broadcasting Beacon frames with the same BSSID but with different source addresses. An IBSS (Independent Basic Service Set) is a type of WLAN that does not use an AP but rather allows stations to communicate directly with each other in a peer-to-peer manner. An IBSS is also known as an ad-hoc network or a peer-to-peer network. In an IBSS, each station generates its own Beacon frames to announce its presence and capabilities to other stations within range. The Beacon frames have the same BSSID, which is randomly generated by one of the stations when creating the IBSS, but they have different source addresses, which are the MAC addresses of each station's radio interface. The BSSID is used to identify the IBSS and prevent stations from joining other IBSSs with different BSSIDs.Reference:, Chapter 1, page 25; , Section 1.1

Show Answer
asked 16/09/2024
Thutcha sudjitjjoon
35 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms