ExamGecko
Search Search Login
Home Home / DELL / D-PST-MN-A-24
Question list
Search
Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

DRAG DROP Order the NDU operational steps.
When a Dell EMC PowerStore node powers up in service mode, what are the commands and sequence used from the appliance SSH client to restore the node back to normal?
Which type of device is supported in expansion enclosures?
Under which condition does the Dell EMC PowerStore equipment in the rack require additional stability?
A Storage Administrator has an existing single appliance Dell EMC PowerStore 3000T cluster. An additional PowerStore 9000T has been purchased to add into the existing cluster. How does the administrator proceed?
A Storage Administrator notices a Critical alert present in Dell EMC PowerStore Manager relating to data integrity. What action within the alert details slide-out panel is helpful in troubleshooting the problem?
What does the output of the PSTCLI command 'nas_server show' display from a Dell EMC PowerStore T?
DRAG DROP Correctly order the steps of the embedded module replacement procedure.
Which component is an FRU?
What is a step in configuring the ToR data switches for a Dell EMC PowerStore T?

Question 54 - D-PST-MN-A-24 discussion

Report
Export

A Storage Administrator needs to connect through SSH to run svc commands. How is the SSH session configured?

A.
NAS server IP address using port 22
Answers
A.
NAS server IP address using port 22
B.
Appliance IP address using port 26
Answers
B.
Appliance IP address using port 26
C.
NAS server IP address using port 26
Answers
C.
NAS server IP address using port 26
D.
Appliance IP address using port 22
Answers
D.
Appliance IP address using port 22
Suggested answer: D

Explanation:

The SSH session for a Storage Administrator to run svc commands on a Dell EMC PowerStore system is configured using the Appliance IP address using port 22.

To connect to the service console over SSH, the Storage Administrator should use the appliance IP address.

The default SSH port for accessing the service console is port 221.

SSH access to the nodes may be required for troubleshooting and is not enabled by default. To enable SSH access:

Navigate to Settings.

Select SSH Management from the Security section.

Choose the appliance or appliances on which to enable SSH.

Click ENABLE SSH1.

The service user account is used for SSH login, and the password is set during the Initial Configuration Wizard (ICW) or can be reset from the PowerStore Manager user interface1.

It's important to note that the SSH port used to log in to the service container is port 22 after the cluster creation is completed. Before the ICW is run, port 26 may be used1.

For detailed instructions on how to connect to the service console over SSH, please refer to the official Dell documentation or contact Dell Support for assistance.

Show Answer
asked 16/09/2024
krishamrock krishqmrock
34 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms